MST FMX 2.0 LCG 1/10 RWD Electric Drift Car Kit (No Body)

The MST FMX 2.0 "LCG" 1/10 RWD Electric Drift Car Set is a mid motor, rear wheel drive set developed with the enthusiast in mind. Featuring high quality carbon fiber and molded composite parts, very smooth shocks and a variety of tuning settings available right out of the box, this set delivers fantastic steering angles in a mid-motor platform that is fantastic for both beginners and knowledgeable enthusiasts alike. This revamped LCG aluminum motor install decreases the center of gravity of the motor by approximately 5mm than the last generation, which even more increases the stability and control. The freshly developed carbon upper deck is separated from the motor install, increasing the torsion of the automobile body, minimizing the height of the upper deck, and more vibrant and structured visual looks.

NOTE: Wheels, tires and electronic devices shown in images are for illustrative functions just and are not consisted of. See required to finish list listed below for a complete list of items needed to finish the model.   

Features:

Middle motor mounts and centralized setups

Carbon fiber chassis with dual vertical carbon fiber upper deck

Redesigned fantastic front suspension system

Adjustable Ackerman angle variation in 2 areas of steering system

Front steering wheel base KPI at 6 degrees. - 0.5 hauling range of axle

Redesigned front upper arm inside seat supports 10-steps bi-side modifications

Full dust-proof rear gearbox with the bevel equipment shaft drive

Standard ball differential

Variable second reduction ratio of the rear axle in an overall of 6 variable variety of 1.78-3.82 (basic 3.82)

Revised MB multi-link rear suspension system

Rear drive system geared up with the steel CVD drive shaft

Standard aluminum smooth hydraulic damper set

Geared up with the high-smooth metal ball connectors

Standard equipping with the sensible automobile brake and caliper set

Resigned aluminum motor install

Updated carbon upper deck

Specs: 

Type: 1:10 Drift Car  

Wheelbase: 257mm 

Width: 190mm  

Drive Mode:  RWD  

Caster: Adjustable 6/8/10/12 degrees  

Camber:  Adjustable 0 to -12 degrees

Needed to Total:

1/10 Wander Body & Paint

Motor & ESC

2 Channel Radio System (minimum)

Steering Servo

Shorty LiPo Battery & Charger

Wheels & Tires