OS Motors Motor Mount 140RX/FS120/120AX/FS200S

This is a motor mount drilled and tapped to fit the
O.S. FS-120 (4-stoke), FS-120 Surpass (4-stroke), 1.40RX (2-stroke)
Includes all hardware needed for mounting the engine to a firewall software and
mounting the engine to the mount. The nose gear hole is not pre-drilled.

CONSISTS OF:
Four engine mounting screws (for mounting the engine to the mount)
Four lock washers (for the engine mounting screws)
Four blind nuts (they suit the firewall)
Four motor mount screws (for secruring the mount to the firewall)
One L-wrench for the screws

SPECIFICATIONS:
Kind Of Material: All Aluminum mount with Steel screws and washers
Type of Mount: Beam design mount with a square shaped back
Length: 90mm (3-1/2")
Width: 54mm (2-1/8")
Height: 54mm (2-1/8")
Mount to firewall screws: M5x25 caphead (coarse)
Engine to mount screws: M5x20 caphead (coarse)

COMMENTS:
Only one of the four mounting holes to mount this to the firewall
is countersunk. This is done to prevent disturbance with 120SIII carb
This would make use of a M5x25 flathead screw which we currently do
not bring.