HPI Nitro Star G3.0 Engine, W/Pullstart, 6.5Mm Rotary Carb, Sg Shaft

This is the HPI Nitro Star G3.0 Engine with Pull Beginner
utilized in the HPI Fire Storm

FEATURES:
Composite body rotary valve carburetor with 5.5mm bore
Silver colored cooling head
SG (pilot) type crankshaft
Two year restricted guarantee

CONSISTS OF:
HPI Nitro Star G3.0 Engine with Pull Start, instruction manual,
    R5 cold glow plug (HPIG1504), foam air cleaner assembly with four
    zip ties, brass collet

NEEDS:
Fuel: Car blend with 20-25% nitro content
Misc Items: Fuel tubing and track equipment

SPECS:
Specs such as horsepower, bore, stroke and RPM were not provided-
    contact HPI for more infomation
High Speed Needle Setting: Turn clockwise in 1/8 turn increments
    to lean fuel mix. Do not exceed 2-1/2 turns from flush
Idle Adjustment: Change for about 0.04" (1mm) gap in between slide valve
    and carb body at bore opening
Low Speed Needle: No adjustment recommended
Displacement: .18 cu in (3.0cc)

Range Between Mounting Holes Very Same Side: 0.43" (11mm)
Range Between Mounting Holes Opposite Side: 1.22" (31mm)
Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99" (76mm)
Height/Bottom of Crankcase to Top of Cylinder Head: 3.5" (89mm)
Length from Pull Beginner to End of Crankshaft: 4.13" (105mm)
Length from Pull Beginner to Front Bearing: 3.3" (75.3mm)
Length from Center of Crankcase to End of Crankshaft: 2.96" (75mm)
Size of Carburetor Bore: 0.21" (5.5mm)