Holmes Hobby SHV800 Servo

The SHV800 is an unbelievable 800 to 1300oz/in servo designed for the high effect penalty of R/C Rock Crawlers and Rock Racers, but frequents any vehicle that requires high torque, ultra quick speeds, and massive equipment strength! It can be powered straight by a 2s to four LiPo battery through JST connection and does not need a BEC! Tidy up your wiring, gain area in a tight rig, and delight in massive performance at industry leading high performance from the high quality brushless motor and circuitry.

FEATURES:

Full aluminum Case with O-Ring Seals

All steel machined gears with industry leading pin strength

Extra-large Brushless motor with 200C ranked Neodymium magnets

24cm radio signal lead

24cm power lead with female JST plug, includes male extension

120 degree rotation

1 Year Service warranty

REQUIREMENTS:

Weight: 94g

Measurements: 38.7x20x40mm

Spline: 25 tooth (Futaba type) M3 threaded

Torque @ 8.4v & 4 amp: 790 oz/inch (57kg/cm)

Speed @ 8.4v: 0.18 sec

Torque @ 12v & 4.1 amp: 1050 oz/inch (75kg/cm)

Speed @ 12v: 0.12 sec

Torque @ 15v & 5.1 amp: 1290 oz/inch (93kg/com)

Speed @ 15v: 0.10 sec

You should utilize a radio with endpoint adjustment for correct installation.  The battery should be disconnected from the ESC AND servo when not in use to prevent damage to the servo and/or battery. Do not power the servo straight from a battery balance port. Doing so can harm the servo and will void the warranty. Moly (marine) grease is suggested when lubing the gears. Dielectric grease is suggested on the power board and potentiometer if aiming to increase water resistance.