HOBBYWING Skywalker 20A Esc

SKYWALKER 20A

Functions:

Security equipping function: Regardless the throttle stick position, the motor will not spin after battery linked

Throttle calibration funtion: Throttle range can be calibrated to be suitable with different transmitters.

User programmable.

Multiple program approaches supported: transmitter stick, LED Program Card. Very easy to set the ESC in the house or at the flying field.

Compatible with Lipo and NiMH battery.

Full security: Low voltage cutoff security / Over-heat security / Throttle signal loss protection.

Specifications:

Output: Constant 20A, Burst 25A approximately 10 seconds.

Input Voltage: 2-3S Lipo, 5-9 cells NiMH.

BEC: 2A / 5V Linear mode BEC.

Refresh rate of the throttle signal: 50Hz to 432Hz

Max Speed: 210000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM.

1.6 Size: 42mm*25mm*8mm.

Here is another item that praises the item being discussed.

Tower Pro SG90 Servo

Functions:
Micro Servo Titan 9g servo
Gear Type : All Nylon Gear
Dead Band Width : 2 usec
Stall Torque : 1.5kg/cm at 4.8V
Operation Voltage : 3.0 - 7.2Volts

Requirements:
Dimension : 23mm x 12mm x 29mm
Port Wire Length : About 248mm
Operating Speed : 0.12sec / 60 degrees (4.8V no load)
Temperature Range : -30 to +60 Degree C
Net weight : about 11g
Color : black

Packaging material:
1 x 9g TITAN Servo Sets (with devices)

You will like this product if you have the product previously mentioned.

300Mm Light Extension Cable (Jr)

HYPERION 300MM LIGHT EXTENSION CABLE (JR)

Frequently purchased with the item that you are currently reviewing.

EC3 Device & Battery Connector


Functions

Capable of 60 continuous ampsErgonomically pleasing and easy to gripProtected to avoid shorting and reverse polaritySuperior technology matched to today's sophisticated applicationsConnectors are factory-installed with ParkZone® F-27C Stryker, E-flite PNP airplane,Designed with benefit and dependability in mind


Introduction

E-flite's top quality EC3 ports and leads must be a staple for each workbench. EC3 (E-flite Port 3.5mm) ports, leads with ports, and devices are ideal for electric power applications and work with any battery, charger, ESC, Power Meter, and so on

The below item additionally sets really well with the item being discussed.

930Kv Brushless Outrunner Motor, 3.17 MM Shaft, 3.5MM Bullet Con

LI-Poly Cell:2-3
Ni-MH Cells: 6-10
RPM/V: 1800Kv
Max. performance current: 6-10 Amp
NoLoad current / 10 V: 0.8 Amp
Present capacity: 16 A/60 s
Max. Effectiveness: 74%
Shaft size: 3mm

A2208-12 similar to: AXI 2208/20, E-Flite Park 370

Want another wonderful item to match the above mentioned item?

9x3.8 Slow Flyer Propeller

This is a 9x3.8 Slo-Flyer "tractor" (not a "pusher") plane propeller.
This prop produces a lot of torque even at low speeds.

FEATURES:
Computer-optimized style gives these props a thinner profile and
    more "bite" with less noise.
Lightweight molded nylon building and construction reduces rotating mass for
    higher output and longer life.
Reinforcing carbon fibers help keep real, constant pitch at
    any rpm.
Slo-Flyer props work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon prop
One set of small shaft locating rings
One locating ring direction sheet

REQUIRES:
ALL props require balancing (use TOPQ5700)
May need prop reamer, use GPMQ5005 (SAE) or GPMQ50007 (Metric)

SPECS:
Length: 9"
Pitch: 3.8
Density of hub: 3/8"
Hole Diameter: ¼"

COMMENTS:
Slo-Flyer props are Not created for Radiance engines