HOBBYWING Skywalker 20A Esc

SKYWALKER 20A

Functions:

Security arming function: Regardless the throttle stick position, the motor will not spin after battery linked

Throttle calibration funtion: Throttle range can be calibrated to be compatible with various transmitters.

User programmable.

Multiple program methods supported: transmitter stick, LED Program Card. Extremely easy to set the ESC in the house or at the flying field.

Compatible with Lipo and NiMH battery.

Full protection: Low voltage cutoff protection / Over-heat protection / Throttle signal loss protection.

Specifications:

Output: Constant 20A, Burst 25A as much as 10 seconds.

Input Voltage: 2-3S Lipo, 5-9 cells NiMH.

BEC: 2A / 5V Linear mode BEC.

Refresh rate of the throttle signal: 50Hz to 432Hz

Max Speed: 210000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM.

1.6 Size: 42mm*25mm*8mm.

Right here is an additional thing that compliments the thing being discussed.

Tower Pro SG90 Servo

Functions:
Micro Servo Titan 9g servo
Gear Type : All Nylon Gear
Dead Band Width : 2 usec
Stall Torque : 1.5kg/cm at 4.8V
Operation Voltage : 3.0 - 7.2Volts

Specs:
Dimension : 23mm x 12mm x 29mm
Connector Wire Length : About 248mm
Running Speed : 0.12sec / 60 degrees (4.8V no load)
Temperature Variety : -30 to +60 Degree C
Net weight : about 11g
Color : black

Packing content:
1 x 9g TITAN Servo Sets (with devices)

You will enjoy this thing if you have the thing above mentioned.

300Mm Light Extension Cable (Jr)

HYPERION 300MM LIGHT EXTENSION CABLE (JR)

Frequently purchased with the thing that you are currently checking out.

EC3 Device & Battery Connector


Functions

Capable of 60 constant ampsErgonomically pleasing and easy to gripProtected to avoid shorting and reverse polaritySuperior innovation suited to today's sophisticated applicationsConnectors are factory-installed with ParkZone® F-27C Stryker, E-flite PNP aircraft,Designed with convenience and reliability in mind


Overview

E-flite's premium EC3 connectors and leads should be a staple for every single workbench. EC3 (E-flite Connector 3.5mm) connectors, leads with connectors, and devices are ideal for electric power applications and work with any battery, battery charger, ESC, Power Meter, and so on

The below thing additionally pairs truly well with the thing being discussed.

930Kv Brushless Outrunner Motor, 3.17 MM Shaft, 3.5MM Bullet Con

LI-Poly Cell:2-3
Ni-MH Cells: 6-10
RPM/V: 1800Kv
Max. effectiveness current: 6-10 Amp
NoLoad current / 10 V: 0.8 Amp
Current capacity: 16 A/60 s
Max. Performance: 74%
Shaft size: 3mm

A2208-12 similar to: AXI 2208/20, E-Flite Park 370

Want an additional fantastic thing to compliment the above pointed out thing?

9x3.8 Slow Flyer Propeller

This is a 9x3.8 Slo-Flyer "tractor" (not a "pusher") plane propeller.
This prop produces a great deal of torque even at low speeds.

FEATURES:
Computer-optimized design gives these props a thinner profile and
    more "bite" with less noise.
Lightweight molded nylon building and construction minimizes turning mass for
    higher output and longer life.
Reinforcing carbon fibers help keep real, continuous pitch at
    any rpm.
Slo-Flyer props work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon prop
One set of small shaft locating rings
One locating ring guideline sheet

NEEDS:
ALL props require balancing (usage TOPQ5700)
May need prop reamer, usage GPMQ5005 (SAE) or GPMQ50007 (Metric)

SPECS:
Length: 9"
Pitch: 3.8
Thickness of center: 3/8"
Hole Diameter: ¼"

REMARKS:
Slo-Flyer props are Not designed for Glow engines