Great Planes Double-Sided Servo Tape 1"x3'

Excellent Airplanes double sided foam servo tape works great for installing servos and
receivers to automobile, aircraft and boat models.

FEATURES:
Super sticky adhesive on both sides for protected holding power

INCLUDES:
One roll of double-sided servo tape

SPECIFICATIONS:
Length: 36"
Width: 1"
Thickness: 1/32"

This item compliments the main item here.

Hs-55 Sub Micro Servo, .14Sec/18Oz @ 6.0V

    This is the Hitec HS-55 Sub Micro (Feather) Servo with a
Futaba J, Hitec S, JR, Airtronics Z-type Connector.

FEATURES:
Very slim case and lightweight for installing in small planes,
    electrics or gliders, where extremely high speed and great torque are
    critical.
One of the slimmest micro servos available.
High-strength resin equipment train offers dependable operation.

INCLUDES:
One HS-55 Servo w/pre-installed small X-shaped servo horn and screw
One extremely small straight servo horn
One M1.7x3 servo horn screw
One small straight servo horn
Two M1.7x7 servo installing screws

at 4.8V
SPECIFICATIONS:
Speed: 0.17 sec at 60°
Output Torque: 15.27 oz-in (1.1 kg-cm)
Weight: 0.27oz (7.8g)
Length: 0.89" (22.8mm)
Width: 0.45" (11.6mm)
Height: 0.94" (24mm)

Here is a great item that many others have bought at the same time.



This is a 17 gram tube of Racers Edge 60/40 Rosin Core Solder. This high quality solder is best for all electronic applications.

This item is often purchased with the above discussed item.



This is a pack of thirty Racers Edge 4" long flourescent green zip tie covers. Zip tie covers make an incredible addition to your pit box, as you can use them to secure wires to your chassis, create pull loops for your fuel tank and perform fast repair works on the fly during a race to your automobile body!

The below item additionally sets truly well with the item being gone over.

Hc Connector M/F (1) Available Only From

This is the Male/Female Traxxas Connectors Plugs Only (No Wires).

FUNCTIONS:
Shrouded wire connections (no diminish tube required)
Wide surface area, gold-plated terminals
Reverse polarity defense makes it impossible to connect in reverse
Textured surface area for simple gripping
Compatible with high-current 12-gauge wire
Secure, favorable locking spring crammed terminals for consistent
    contact
Several locking barbs keep terminals secure

INCLUDES:
One black female plastic adapter
One black male plastic adapter
Two sets of gold metal pins
Instruction sheet

REQUIRES:
Soldering wires to the metal pins

Want one more great item to enhance the above discussed item?

26T Pinion 48P

This is a 26 Tooth, 48 Pitch Pinion Equipment with Set Screw
from Traxxas.

FEATURES:
Steel building, silver in color

INCLUDES:
One 26 Tooth, 48 Pitch Pinion Equipment
One 3x4mm Set Screw (1.5mm hex size)

REQUIRES:
Setup

SPECIFICATIONS:
Length: .42" (10.5mm)
Inside Size: 1/8"
Outdoors Size: .58" (14mm)

This item is often purchased with the above discussed item.

Box, Receiver For Stmpd, Rstlr, Bandt

This is the Receiver Box for usage on the
Traxxas Stampede, Rustler, and Bandit Vehicles.

FEATURES:
Nylon building
Black in color

INCLUDES:
One Receiver Box
One Rubber Seal
Foam Padding
Two 2.5x8mm Cap Head Screws
Two 3x10mm Cap Head Screws
Two 2.5x10mm Cap Head Screws
One Tube of Grease
Instruction sheet

REQUIRES:
Setup on the vehicle

SPECIFICATIONS:
Length: 78mm (3.07")
Width: 35mm (1.4")
Height: 33mm (1.3")