E-Flite Power 160 Brushless Outrunner Motor, 245Kv

Functions

Comparable to or surpassing the power of a 160-size, 2-stroke, glow engine for 12–20 lb (5.4–9 kg) aircrafts
Suitable for 3D aircrafts approximately 15 lb (6.8 kg)
High-torque alternative to inrunner brushless motors
Includes mount and mounting hardware
External rotor design for better cooling
High-quality construction with ball bearings and solidified 8mm steel shaft
Includes 2 12mm prop shaft adapters tapped out for 10–32 threads
Suitable for models needing approximately 2700 watts of power
Slotted 14-pole outrunner design

Summary

The Power 160 is designed to provide clean and peaceful power equivalent to or surpassing the power of a 160-size 2-stroke glow engine for sport and scale aircrafts weighing 12 to 20 pounds (5.4 to 9 kg), 3D aircrafts approximately 15 pounds (6.8 kg), or models needing approximately 2700 watts of power.
It provides exceptional power for the popular 27% scale aerobatic models such as the Garage 9 Extra 260, scale efficiency for the Garage 9 P-47D Thunderbolt 150 ARF, and severe efficiency for models like the well-known Ultra Stick Lite.



Maximum operating temperature level: 220 degrees Fahrenheit.

Adequate cooling is required for all motor operation at optimal current levels.

Maximum burst current duration is 15 seconds. Adequate time between maximum burst periods is required.

You will need...
75A-110A HV brushless ESC
9S–10S Li-Po or 28- to 32-cell Ni-MH/Ni-Cd
18x8 to 20x10 prop

Requirements

Type: Brushless outrunner
Size: Equivalent to or surpassing the power of a 160-size 2-stroke glow engine
Bearings or Bushings: One 8 x 19 x 6mm Bearing, and Two 8 x 16 x 5 Bearings
Wire Gauge: 13
Recommended Prop Variety: 18x8 to 20x10
Voltage: 33.3–38.4
RPM/Volt (Kv): 245
Resistance (Ri): .03 ohms
Idle Present (Io): 1.45A @ 10V
Continuous Present: 60A
Optimum Burst Current: 78A (15 sec)
Cells: 28–32 Ni-MH/Ni-Cd or 9S–10S Li-Po
Speed Control: 75–110A High Voltage Brushless
Weight: 650 g (23.0 oz)
General Diameter: 63mm (2.50 in)
Shaft Diameter: 8mm (.30 in) (Includes 2 12mm threaded prop shaft adapters with 1.5 pitch)
General Length: 64mm (2.50 in)