E-Flite Power 160 Brushless Outrunner Motor, 245Kv

Functions

Equivalent to or going beyond the power of a 160-size, 2-stroke, radiance engine for 12–20 lb (5.4–9 kg) airplanes
Suitable for 3D airplanes approximately 15 lb (6.8 kg)
High-torque option to inrunner brushless motors
Consists of install and mounting hardware
External rotor style for better cooling
High-quality construction with ball bearings and solidified 8mm steel shaft
Consists of two 12mm prop shaft adapters tapped out for 10–32 threads
Suitable for designs requiring approximately 2700 watts of power
Slotted 14-pole outrunner style

Introduction

The Power 160 is developed to deliver clean and quiet power equivalent to or going beyond the power of a 160-size 2-stroke radiance engine for sport and scale airplanes weighing 12 to 20 pounds (5.4 to 9 kg), 3D airplanes approximately 15 pounds (6.8 kg), or designs requiring approximately 2700 watts of power.
It supplies exceptional power for the popular 27% scale aerobatic designs such as the Hangar 9 Extra 260, scale efficiency for the Hangar 9 P-47D Thunderbolt 150 ARF, and extreme efficiency for designs like the popular Ultra Stick Lite.



Maximum running temperature: 220 degrees Fahrenheit.

Adequate cooling is needed for all motor operation at optimal current levels.

Maximum burst current duration is 15 seconds. Sufficient time in between maximum burst periods is required.

You will need...
75A-110A HV brushless ESC
NINE–10S Li-Po or 28- to 32-cell Ni-MH/Ni-Cd
18x8 to 20x10 prop

Requirements

Type: Brushless outrunner
Size: Equivalent to or going beyond the power of a 160-size 2-stroke radiance engine
Bearings or Bushings: One 8 x 19 x 6mm Bearing, and Two 8 x 16 x 5 Bearings
Wire Gauge: 13
Recommended Prop Variety: 18x8 to 20x10
Voltage: 33.3–38.4
RPM/Volt (Kv): 245
Resistance (Ri): .03 ohms
Idle Existing (Io): 1.45A @ 10V
Continuous Existing: 60A
Optimum Burst Current: 78A (15 sec)
Cells: 28–32 Ni-MH/Ni-Cd or NINE–10S Li-Po
Speed Control: 75–110A High Voltage Brushless
Weight: 650 g (23.0 oz)
General Diameter: 63mm (2.50 in)
Shaft Diameter: 8mm (.30 in) (Consists of two 12mm threaded prop shaft adapters with 1.5 pitch)
General Length: 64mm (2.50 in)