Dromida Steering Bellcrank Assembly BX MT SC 4.18

This is the Steering Bellcrank Assembly
for the Dromida BX, MT, and SC Vehicles.

FEATURES:
Plastic building and construction

CONSISTS OF:
Drag Link
One Right and one Left Steering Bellcrank
Two 2x8mm Round Head Shoulder Screws

COMMENTS:
The 2 Ballstuds shown in the parts list of the handbook are not
    included. Order DIDC1034 if these ballstuds are needed.

You will like this thing if you have the thing earlier pointed out.



This is the Servo Saver Set for the Dromida SC, MT and BX Vehicles.

FEATURES:
Metal and plastic building and construction
Helps to avoid damage to the servo in case of a front end
    collision

CONSISTS OF:
Spline, Arm, Spring, and Cap
One 2x10mm Round Head Maker Screw
One 2.6x5mm Washer

Lots of others have actually acquired this item along with the item that you are currently reading about.



Want one more terrific item to enhance the above discussed item?

Dogbone Set BX MT SC 4.18 (4)

This is the Dogbone Set for the Dromida BX, MT, and SC Vehicles.

FEATURES:
Plastic building and construction with steel pins
Fits front and rear drive systems

CONSISTS OF:
Four Dogbones

This item is often acquired with the above discussed item.

Hub Carrier Front BX MT SC 4.18 (2)

The below item also sets actually well with the item being talked about.

Drive Shaft Spacer Set BX MT SC 4.18

This is the Drive Shaft Spacer Set
for the Dromida SC4.18, MT4.18 and BX4.18 Vehicles.

FEATURES:
Installs on either side of put together differential

CONSISTS OF:
Four O-Rings
    Four Springs, essential #35

This item compliments the above talked about item.

Body Clip BX MT SC 4.18 (10)

These are the Body Clips for the Dromida SC, MT and BX Vehicles.

FEATURES:
Steel building and construction

CONSISTS OF:
10 Body Clips

This is a superb enhancement to the item currently being talked about.

Screw/Hardware Set BX MT SC 4.18

This is the Screw and Hardware set for the Dromida SC4.18, MT4.18,
and BX4.18 Vehicles.

FEATURES:
Steel building and construction
Sizes separately packaged

CONSISTS OF:
All Screws, Locknuts, E-Clips, Washers, Set Screw and Body Clips
    used in the assembly of the Dromida vehicles

Below is a terrific item that numerous others have actually bought at the exact same time.

Linkage Set BX MT SC 4.18

This is the Linkage Set for the Dromida BX, MT, and SC Vehicles.

FEATURES:
Plastic and metal building and construction

CONSISTS OF:
Two Plastic Tie Rods
Steering Rod with Ball Cups
Four Metal Camber Rods with eight Long Ball Cups

This item compliments the above talked about item.

Suspension Arm Lower BX MT SC 4.18 (2)

These are the Lower Suspension Arms for the Dromida SC, MT and BX Vehicles.

FEATURES:
Plastic building and construction
Fits front or rear suspension

CONSISTS OF:
Two Lower Suspension Arms