Axial Input Shaft 5x29mm (2)

These are the Input Shafts for the Axial Wraith Rock Racer.

FEATURES:
Steel building and construction
Holds bevel gear in location inside transmission

CONSISTS OF:
2 5x29mm Input Shafts

REQUIRES:
Disassembly of transmission to install

This item is often acquired with the above pointed out item.

E-Clip E2.5 (10)

This is the 2.5mm E-Clips for the Axial Rock Crawler.

FEATURES:
Metal building and construction, silver in color

CONSISTS OF:
10 2.5mm e-clips

REQUIRES:
Installation to the design

The listed below item additionally pairs truly well with the item being gone over.



These are the optional ST Racing Front and Rear Lower Suspension Links
for the Axial SCX10.

FEATURES:
CNC machined aluminum building and construction, silver in color
Fits the Axial SCX10 automobiles with a wheelbase of 12" (305mm)
    including the Deadbolt, Falken Tires JK, and Recon G6 JK

CONSISTS OF:
2 Front Links
2 Rear Links
Eight M3x16mm Set Screws

REQUIRES:
2 AX80005 Axial Rod Ends, AXIC3805
2 AX80018 Axial Rod End Links, AXIC3818

COMMENTS:
(Any unique application or something it will not work with?)

The listed below item additionally pairs truly well with the item being gone over.

Castle Bec 10Amp (25 Volt Max Input)

This is the CC BEC 10A Receiver Battery Remover by Castle Creations.

FEATURES:
Eliminates the need for a receiver and servo battery pack
Draws greater voltage from the motor batteries and drops it to a
    voltage level appropriate for the receiver and servos

CONSISTS OF:
One CC BEC receiver battery eliminator

REQUIRES:
Installation in the aircraft

SPECIFICATIONS:
Length: 1.2" (30mm)
Width: .6" (15mm)
Height: .4" (10mm)
Weight: .4oz (11g)
Input voltage: 5V to 25.2V (TWO to 6S LiPo)
Existing output: 12 volts input = 7 amps* continuous, 10 amp peak;
    24 volts input = 5 amps* continuous, 7 amp peak
    *Ratings are determined with a 5mph air flow on the BEC
Selectable Output: 4.8 - 9.0V through the Castle Link (sold independently)
    Default voltage is 5.1V

Want an additional great item to compliment the above pointed out item?



This is the replacement Bevel Gear Set for the
Axial AX10 Scorpion Rock Crawler.

FEATURES:
Aluminum building and construction, silver in color
Changes a used or broken bevel gear set

CONSISTS OF:
One 38 Tooth Large Bevel Gear
One 13 Tooth Small Bevel Gear

REQUIRES:
Installation following the design handbook

COMMENTS:
For the sturdy version of this gear set order AXIC0395