Axial Body Clip 6mm Black (10)

This is a bundle of 10 Body Clips from Axial.

FEATURES:
Steel building, black in color

CONSISTS OF:
10 6mm body clips

SPECS:
Length: .82" (21mm)

You will certainly enjoy this thing if you have the thing above stated.

Landing Skid

Requirements:
Landing skid x 1
Washer x 2(Φ2.6xΦ5.8x0.6mm)
Socket button head screw x 2(M2.5x10mm)

Right here is a terrific thing that several others have actually bought at the exact same time.

Hexagon Screw Driver

Using on heli's M2 socket screw and M3 socket screw!

Requirements:
1.5mm(Black/26.6g)x1
2.0mm(Blue/28.6g)x1
2.5mm(Purple/29.5g)x1
3.0mm(Red/31g)x1

Want one more terrific thing to enhance the above stated thing?



This is the DuraTrax NiMH 7.2V 5000mAh Onyx Stick Battery Pack
with Requirement Connector.

FEATURES:
Perfect sport pack for automobiles, trucks and boats

CONSISTS OF:
DuraTrax NiMH 7.2V 5000mAh Onyx Stick Battery with Conventional
    Connector

REQUIRES:
NiMH compatible charger such as the Duratrax Onyx series

SPECS:
Capacity: 5000mAh
Variety of Cells in Series: 6
Ranked Voltage: 7.2V
Minutes. Discharge Voltage: 5.4V
Maximum Recommended Charge Current: 5 amps
Discharge Lead: 14AWG 2.7" (70mm) long wire w/Standard port
Pack Measurements: 5.3 x 1.8 x 0.94" (135 x 45 x 24mm)
Weight: 15.6 oz (442 g)
Variety of Welds per Connection: 6 area welds
Cell Size: Sub-C

The below thing additionally pairs actually well with the thing being talked about.



This is the 7.4V 2S 15C 250mAh LiPo Battery from Venom-Group.

FEATURES:
Created for usage with the Losi micro 1/24 scale rally automobiles, 4WD
    short course trucks and small indoor aircraft
Pre-wired with a Molex 51005 port and XH design balance port

CONSISTS OF:
7.4V 2S 15C 250mAh LiPo Battery with Molex 51005 Connector and XH
    Balance Connector

REQUIRES:
LiPo charger with balancing ability

SPECS:
Setup: 2S1P
Weight: 0.56 oz (16g)
Measurements: 1.3 x 0.51 x 0.83" (33 x 13 x 21mm)
Constant Discharge: 15C (3.75A)
Max Burst Rate: 30C (7.5A)
Watt Hours: 1.85

REMARKS:
READ the ENTIRE instructions before usage
ALWAYS utilize a LiPo-approved charger
ALWAYS utilize a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER Charge through the "To ESC or "DISCHARGE" lead
NEVER Trickle Charge
NEVER allow to Discharge listed below 2.5V per cell
NEVER take apart or customize pack electrical wiring in any way or leak cells
NEVER place on flammable materials or leave unattended during
    Charging
ALWAYS charge in a fireproof area
ALWAYS set charger's output volts to match battery volts
CONSTANTLY shut out of reach of children

This thing compliments the above talked about thing.

Spurs 48DP 87T

This is the 48 Pitch 87 Tooth Spur Gear for the Scorpion Rock Spider AXIC9001.

FEATURES:
Black plastic building

CONSISTS OF:
One 48DP 87T stimulate gear

REQUIRES:
Setup on the Rock Spider

Many others have actually bought this thing in addition to the thing that you are currently reviewing.

Hex Socket Button Head Black M3x6mm (10)

These are the 3x6mm Hex Socket Button Head Screws used on the
Axial Wraith Rock Racer.

FEATURES:
Steel building, black in color

CONSISTS OF:
10 3x6mm Hex Socket Button Head Screws

REQUIRES:
2mm hex wrench, GPMR8011

SPECS:
Length: 6mm
Diameter: 3mm