ARRMA BLX185 6S ESC

This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by 2 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh
    minimum requirement
6.0V/3A continuous output, 12A max
Bridge port for utilizing single FOUR or 6S battery
Over voltage and get too hot security
Two stage LiPo cutoff, single stage NiMH cutoff
Temperature security mode if ESC temperature surpasses 221°F
    (105°C)
Integrated cooling fan to lower heat during severe running
Water resistant under normal usage
Integrated hold down tabs easily secure inside lorry chassis
Set up for use from factory, settings might be changed

CONSISTS OF:
BLX185 6S ESC with Cooling Fan, 2 Collect XT90 Battery Connectors
    with 10AWG Wires, Receiver Plug, Power Switch and Set Button
    10AWG Motor Wires with 4mm Size Gold Plated Female Connectors,
    Instructions and Bridge Connector

NEEDS:
Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, ARAG2000

SPECIFICATIONS:
Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) consisting of hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Switch Length: 1.15" (29.3mm)
Switch Width: 0.5" (12.8mm)
Switch Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) consisting of port
Motor Limitation: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: Two Collect XT90
BEC Voltage: 6.0V
BEC Current Minimum Continuous: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Defense: Over 6S LiPo (22.2V)
Continouous Amp Score: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Handbook via pushbutton
User Programmable: Yes, via button just
Battery Mode: LiPo/NiMH, default LiPo mode