APC 10x4.7 Slow Flyer Propeller

This is a 10x4.7 Slo-Flyer "tractor" (not a "pusher") aircraft propeller.
This prop produces a great deal of torque even at low speeds.

FEATURES:
Computer-optimized design gives these props a thinner profile and
    more "bite" with less noise.
Lightweight formed nylon building minimizes turning mass for
    greater output and longer life.
Reinforcing carbon fibers assist preserve true, continuous pitch at
    any rpm.
Slo-Flyer propellers work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon propeller
One set of little shaft finding rings
One finding ring guideline sheet

REQUIRES:
ALL props require balancing (use TOPQ5700)
May need prop reamer, use GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECIFICATIONS:
Length: 10"
Pitch: 4.7

COMMENTS:
Slo-Flyer props are Not designed for Radiance engines

Lots of others have purchased this thing in addition to the thing that you are presently reading about.

10x4.7 Slow Flyer Pusher

This is the APC 10x4.7 Slo-Flyer Pusher Electric Propeller.

FEATURES:
Opponent electrical and Park-Flyer type airplane
Pusher propellers formed in the opposite instructions from standard
    propellers, they are designed for airplanes with the motor facing
    in reverse in the back of the airplane, PUSHING the aircraft forward
Lightweight molded nylon building minimizes turning mass for
    greater output and longer life
Enhancing fibers assist preserve true, continuous pitch at any RPM

INCLUDES:
APC 10x4.7 Slo-Flyer Pusher Electric Propeller
0.236" (5.9mm) and 0.188" (4.8mm) finding rings
Direction sheet

REQUIRES:
ALL props require balancing (use TOPQ5700)
May need prop reamer, use GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECIFICATIONS:
Length: 10"
Pitch: 4.7"

COMMENTS:
Slo-Flyer props cannot be used on radiance or gasoline powered engines

Below is a excellent thing that many others have purchased the very same time.

Tower Pro SG90 Servo

Features:
Micro Servo Titan 9g servo
Equipment Type : All Nylon Equipment
Dead Band Width : 2 usec
Stall Torque : 1.5kg/cm at 4.8V
Operation Voltage : 3.0 - 7.2Volts

Specs:
Measurement : 23mm x 12mm x 29mm
Connector Wire Length : About 248mm
Operating Speed : 0.12sec / 60 degrees (4.8V no load)
Temperature Variety : -30 to +60 Degree C
Net weight : about 11g
Color : black

Packing content:
1 x 9g TITAN Servo Sets (with accessories)

Below is an additional thing that compliments the thing being gone over.

9x4.7 Slow Flyer Propeller

This is a 9x4.7 Slo-Flyer "tractor" (not a "pusher") aircraft propeller.
This prop produces a great deal of torque even at low speeds.

FEATURES:
Computer-optimized design gives these props a thinner profile and
    more "bite" with less noise.
Composite building
Enhancing carbon fibers assist preserve true, continuous pitch at
    any rpm.
Slo-Flyer propellers work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon propeller
One set of little shaft finding rings
One finding ring guideline sheet

REQUIRES:
ALL props require balancing (use TOPQ5700)
May need prop reamer, use GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECIFICATIONS:
Length: 9"
Pitch: 4.7

COMMENTS:
Slo-Flyer props are Not designed for Radiance engines