Align Swashplate Leveler

Usage for T-REX 550/600/700/800 all class device.

Specs:
Swashplate device corrector ? 1
Collar ? 1(Φ13.5xΦ10x20.5mm)
M3 Set screw ? 1(3x3mm)

Get this product to improve the one you are reading around.

AP800 Digital Pitch Gauge

This is the Align AP800 Digital Pitch Gauge. Developed by Align's R&D group, the AP800 digital pitch gauge is suitable for flybar and flybarless helicopters and includes an auto-detecting Horizontal level, and the results are displayed through a high contrast LCD screen, supplying a basic and exact way to measure pitch angles.
Features:
Auto-detecting Horizontal level.
Uses backlighting LCD monitor.
No and Lock function.
Noticeable pitch variety: -90? ~ 90?.
Automatic screen rotation.
Suitable for 200~800mm main blades.
Build-in energy conserving function, power shuts down after 3 minutes without any movement.
Specifications:

Body Dimension: 108x53.9x16mm

Suitable blade width: 20mm~74mm

Noticeable pitch variety: ?90?

Resolution: 0.1?

Battery: 2x CR 2032 Lithium

Weight: 38g (consisting of battery)

This product praises the main item here.

Servo line Color Black & Green

Planning to clean up the look of your helicopter, plane of RC car & protect your servo lines from chaffing? Servo Line Covering is a simple way to protect your servo wires, including a tidy, aesthetic want to your RC device, and can be set up in a matter of minutes. Select from our exciting line of different colors to include a whole make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, therefore offering you a flush, tight fit over the previously frayed servo covering. Do the very same with completion of your servo wire, bewaring to leave the terminal bare so it can quickly connected into your receiver. Likewise, make sure to keep in mind of the servo wire polarity if you cover the full wire – this will ensure that you will know what direction to plug your servo terminal into your receiver.