Align Swashplate Leveler

Usage for T-REX 550/600/700/800 all class device.

Specs:
Swashplate device corrector ? 1
Collar ? 1(Φ13.5xΦ10x20.5mm)
M3 Set screw ? 1(3x3mm)

Get this product to boost the one you read about.

AP800 Digital Pitch Gauge

This is the Align AP800 Digital Pitch Gauge. Developed by Align's R&D team, the AP800 digital pitch gauge is appropriate for flybar and flybarless helicopters and features an auto-detecting Horizontal level, and the results are shown through a high contrast LCD screen, providing a simple and accurate way to determine pitch angles.
Features:
Auto-detecting Horizontal level.
Uses backlighting LCD keep track of.
Absolutely no and Lock function.
Detectable pitch variety: -90? ~ 90?.
Automatic screen rotation.
Ideal for 200~800mm primary blades.
Build-in energy conserving function, power shuts down after 3 minutes without any movement.
Specifications:

Body Measurement: 108x53.9x16mm

Ideal blade width: 20mm~74mm

Detectable pitch variety: ?90?

Resolution: 0.1?

Battery: 2x CR 2032 Lithium

Weight: 38g (consisting of battery)

This product praises the main item here.

Servo line Color Black & Green

Planning to tidy up the appearance of your helicopter, airplane of RC vehicle & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, including a clean, aesthetic seek to your RC device, and can be installed in a matter of minutes. Choose from our exciting line of varied colors to include an entire make over to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, thus offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with completion of your servo wire, being careful to leave the terminal bare so it can easily plug into your receiver. Also, be sure to take note of the servo wire polarity if you cover the complete wire – this will make sure that you will understand what direction to plug your servo terminal into your receiver.