Align Swashplate Leveler

Use for T-REX 550/600/700/800 all class device.

Specs:
Swashplate system corrector ? 1
Collar ? 1(Φ13.5xΦ10x20.5mm)
M3 Set screw ? 1(3x3mm)

Get this product to improve the one you are reading around.

AP800 Digital Pitch Gauge

This is the Align AP800 Digital Pitch Gauge. Established by Align's R&D team, the AP800 digital pitch gauge is ideal for flybar and flybarless helicopters and includes an auto-detecting Horizontal level, and the outcomes are shown through a high contrast LCD screen, offering a simple and exact way to determine pitch angles.
Features:
Auto-detecting Horizontal level.
Utilizes backlighting LCD keep track of.
No and Lock function.
Noticeable pitch range: -90? ~ 90?.
Automatic screen rotation.
Suitable for 200~800mm primary blades.
Build-in energy conserving function, power closes down after 3 minutes without any movement.
Specifications:

Body Dimension: 108x53.9x16mm

Suitable blade width: 20mm~74mm

Noticeable pitch range: ?90?

Resolution: 0.1?

Battery: 2x CR 2032 Lithium

Weight: 38g (including battery)

This product compliments the main item below.

Servo line Color Black & Green

Aiming to clean up the appearance of your helicopter, aircraft of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, adding a clean, visual want to your RC device, and can be set up in a matter of minutes. Select from our exciting line of different colors to add a whole new look to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, therefore providing you a flush, tight fit over the previously frayed servo covering. Do the exact same with completion of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Also, make certain to remember of the servo wire polarity if you cover the complete wire – this will ensure that you will know what instructions to plug your servo terminal into your receiver.