Align T-REX 600E PRO DFC Combo (No 3GX)

Specification(T-REX 600E PRO DFC) :
1.Equipped with the low CG DFC rotor head, effectively lower wind resistance during flight, offering the most direct and exact control feel back to the pilot, and displays thrilling 3D efficiency and unimaginable flight speed.
2.The frame uses 2mm carbon fiber plates of the greatest specification. Trademarked composite product building strategy cleverly make use of frame area that improved general rigidness, as well as developed a minimalistic beauty.
3.Innovative moving battery tray rails imbedded into the 3K side frames, with patented spring packed latching system, allowing for quick battery gain access to as well as battery protection.
4.Heatsink embedded into motor install for effective cooling of motor.
5.Top installed motor base bringing the motor?s center of mass better to rotating disc, enhancing 3D dexterity.
6.Use direct link CCPM swashplate control system to enable direct and fast control response. Specifically developed anodized CNC servo horns are not just visually pleasing, however are incredibly stiff.
7.Makes use of greatest spec CNC modue-1 helical primary equipment, with greatest load tolerance and most affordable noise.
8.The most optimal motor pinion ratio and tail equipment ratio to achieve the most effective power output and flight particular.
9.High quality 5mm carbon rod and CNC metal tail scissor control arms are utilized in rudder control system to enhance rudder lockingand control efficiency.
10.Extra radial bearing is contributed to the one method bearing block to guarantee smooth rotation, and eliminate jammed one method bearing.
11.Brand new 600 class 12S high voltage brushless motor offering generous torque and power output, yet takes in lower average current to prolong the life of batteries
12.Motor install consists of 3rd bearing block to offer motor shaft assistance, effectively lower torque caused shifts, and minimize equipment striping problem.
13.High quality new tail transmission style, combined with new dual point installed tail pitch control assembly to minimize slops and increase rudder control accuracy.
14.Brand new CNC machined metal tail transmission, with thicker side plates to increase rigidness. The more streamlined style likewise permits easier disassembly.
15.Total pitch series of +15~-15 degrees, for the supreme 3D explosive power.
16.Tail pitch system equipped with high accuracy bearing.
17.High speed thrust bearings in tail blade grips.
18.New lightened landing equipment assembly with lower center of mass.
19.High quality painted fiberglass canopy with 4-point quick release mounts.

Users need to have a specific idea of security to run the R/C helicopters.
Be sure to read and adhere to related safety notes of user's manual prior to flying.

Specification(T-REX 600E PRO DFC):
Length: 1174mm
Height: 319mm
Width: 210mm
Main Blade Length: 600mm
Main Rotor Diameter: 1347mm
Tail Rotor Diameter: 260mm
Motor Drive Gear:13T
Main Drive Gear:112T
Autorotation Tail Drive Gear: 131T
Tail Drive Gear: 34T
Drive Gear Ratio: 1:8.61:3.85
Weight(With Motor): 2290g

Accessories:
T-REX 600E PRO DFC Packages Set X1
600 3G Carbon fiber blades X1
600MX Brushless Motor(510KV) X1
DS615 Requirement servo X3
DS655 Specialized servo X1
Castle ICE2 HV 80 Brushless ESC X1
6A External BEC w/ 5.1V Two-way Step-down voltage regulator X1

Radio transmitter and electronic devices required for assembly:
Transmitter(7-channel or more, helicopter system)
Receiver(7-channel or more)
6S Li-Po 2600 ~ 4600mAh X2 (3300mAh idea)
Dial Pitch Gauge or Digital Pitch Gauge
3GX Flybarless System X1