Align T-Rex 500 PRO DFC Combo Helicopter Kit (No 3GX)

This is the Align T-REX 500 PRO DFC Flybarless Super Combination Helicopter Kit 3GX Not Consisted of. This unbelievable bundle includes not only the T-REX 500 PRO DFC Kit, but likewise a 425 3G Carbon Fiber blade set, 3 DS515M digital cyclic servos, one DS525M digital tail servo, the RCE-BL70G Brushless Electronic Speed Control and the effective 500MX, 1600kV Brushless motor. This very combo offers you with an extraordinary helicopter kit and an equally remarkable electronic bundle all in one box. Just add the 3GX Progammable Flybarless System (AGNHEG3GX01) to this helicopter bundle for remarkable flight efficiency.
T-REX 500 PRO Features: The Align 500 PRO DFC helicopter is geared up with an incredibly low CG design to successfully minimize wind resistance during flight and supply the most direct and precise control feel back to the pilot, supplying exhilarating 3D efficiency and inconceivable flight speed.
A uniquely carbon composite innovation successfully reinforce the weak areas and offers simplified electronic devices installation.
The servos can be mounted directly onto the frame without installing nuts.
The rear servo is mounted in-frame for a central design and optimal 3D efficiency.
MX series high effectiveness brushless motor consisted of with heatsink design housing and ingrained fan to drastically improve cooling and increase power output.
Distinct fast release gyro and receiver install design for fast elimination and sturdy accessory.
High precision slant tooth (helical) main gear for higher load sustainability and lower noise output.
Redesigned tail gear box with higher material quality and simple maintenance.
High quality tail transmission design, combined with upgraded dual point mounted tail pitch control assembly to minimize slop and increase rudder control precision.
Highly efficient shaft owned tail system which successfully minimize power loss found on belt owned systems. This likewise increases efficiency during flight.
Redesigned 4mm carbon rudder control rod and metal rudder pitch bell crank to more improve the rudder locking effect and controllability.
Redesigned design battery installing platform to reinforce the frame in addition to to supply a mount for the electronic speed controller.
Redesigned lower CG landing gear design.
Styled aerodynamically canopy for the ultimate fit, making the helicopter stand out.
Finest tail gear ratio to minimize vibrations brought on by the high speed operations of the main blades, bringing the best tail locking power.

T-REX 500 PRO Specifications:

Length: 868mm

Height: 275mm

Main Blade Length: 425mm

Main Rotor Diameter: 978mm

Tail Rotor Diameter: 206mm

Motor Drive Gear: 12T

Main Drive Gear: 134T

Autorotation Tail Own Gear: 145T

Tail Own Gear: 36T

Own Gear Ratio: 1:11.17:4.03

Weight (With Motor): 1210g

Consists of: (1) T-REX 500 PRO DFC Kit
(1) 425 3G Carbon Fiber blades


(1) 500MX Brushless Motor (1600kV)
(3) DS515M Digital servo


(1) DS525M Digital servo


(1) RCE-BL70G Brushless ESC 

Had to Total:


Transmitter (7-channel or more, helicopter system)
Receiver (7-channel or more)
(2) SIX LiPo Battery Load 2600 ~ 4600mAh (3300mAh recommended)
Digital Pitch Gauge
3GX Flybarless System