Align 3S1P Li-Poly Battery 30C (11.1V/850mAh)

This is an Align 3S1P, 30C, 11.1V, 850mAh Li-Polymer Battery. This Li-poly battery includes high performance and high discharge abilities, making this pack ideal for the TREX 250 series as well as design planes, and any other application that could benefit from a 30C 3S pack with these specifications.

Specifications:
Type: Lithium Polymer
Capacity: 850mAh
Voltage: 11.1V nominal
Variety of Cells: 3
Weight: 70 grams (Not including connectors)
Setup: 3S1P
Measurements: 55x30x24.5mm
Optimum Constant Discharge: 30C
Optimum Burst Discharge: 40C

ESSENTIAL:
1) You will need a Li-Poly specific battery charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
2) You should not over discharge the Li-Poly battery pack.
3) Read the directions carefully before operating this battery.

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of limit capacity of the pack after complete charging to guarantee a good cycle efficiency. It is recommended to totally charge a brand name new battery before using and only release the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage caution on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage.

Do not expose batteries to sunlight or store/charge batteries at the temperature level above 35?C or in a closed vehicle. The high temperature level environment could trigger damage to the pack or make it burst. If the battery ends up being hot while fast charging, high present discharging or racing, do not charge the battery up until it has actually cooled totally. Wait about 20 mins, then examine prior to recharging.