Align 3S1P Li-Poly Battery 30C (11.1V/2200mAh)

This is a Align 3S1P Li-Polymer Battery, and is planned for use with the Align T-Rex 450 line of helicopters.

Features:

This Li-poly battery is using series/balancing design. It features high effective and high discharge, and a inspection maker is utilized to match packs.


Suitable for T-Rex 450 series


Advise to release the battery within 80% of rated discharge, keep 90% capability when over 100 cycles, keep 85% capability when over 150 cycles.(The cycle life and performance will reduce due to high existing, high temperature and over-discharge)

Specs:

Max Continuous Discharge: 30C

Break Discharge: 40C

Small Operating Temperature level: Approximate. 40-64?C (104-147?F) (within 80% of rated discharge)

Optimum Temperature level: 80?C (176?F)

Output: 11.1V(3S1P)2200mAh 

Measurement: 36x104x22mm

Weight: 165g

Note: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capability cannot go beyond 80% of limit capability of the pack after complete charging to guarantee a good cycle performance. It is suggested to totally charge a brand name new battery before using and just release the battery 50% for very first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not utilize the battery that has too low a voltage.



Do not expose batteries to sunlight or store/charge batteries at the temperature above 35?C or in a closed automobile. The high temperature environment could trigger damage to the pack or make it burst. If the battery ends up being hot while fast charging, high existing discharging or racing, do not charge the battery till it has actually cooled completely. Wait about 20 mins, then check prior to recharging.