ARRMA BLX185 6S ESC

This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by 2 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh
    minimum requirement
6.0V/3A constant output, 12A max
Bridge connector for using single FOUR or 6S battery
Over voltage and get too hot security
Two stage LiPo cutoff, single stage NiMH cutoff
Temperature level security mode if ESC temperature level goes beyond 221°F
    (105°C)
Integrated cooling fan to lower heat during extreme running
Water resistant under normal use
Integrated hold down tabs easily safe and secure inside car chassis
Establish for usage from factory, settings might be changed

CONSISTS OF:
BLX185 6S ESC with Cooling Fan, 2 Amass XT90 Battery Connectors
    with 10AWG Wires, Receiver Plug, Power Change and Set Button
    10AWG Motor Wires with 4mm Diameter Gold Plated Female Connectors,
    Directions and Bridge Adapter

REQUIRES:
Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, ARAG2000

SPECIFICATIONS:
Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) including hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Change Length: 1.15" (29.3mm)
Change Width: 0.5" (12.8mm)
Change Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) including connector
Motor Limit: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: Two Amass XT90
BEC Voltage: 6.0V
BEC Current Minimum Continuous: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Defense: Over 6S LiPo (22.2V)
Continouous Amp Rating: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Handbook via pushbutton
User Programmable: Yes, via button only
Battery Mode: LiPo/NiMH, default LiPo mode