Traxxas Yokes Diff/Tranny

These are the Diff and Trans Drive Yokes for the Traxxas T-Maxx 3.3. TRAC78**

FUNCTIONS:
Black plastic building

CONSISTS OF:
2 drive yokes
2 4x15mm Yoke pins

REQUIRES:
T-Maxx 3.3

SPECIFICATIONS:
Length: 15/16" (23mm)
Size: 3/4" (17mm)

You will certainly enjoy this product if you have the product earlier mentioned.

Center Half Shafts E-Revo

This is the Center Half Shaft Set for the Traxxas E-Revo

FUNCTIONS:
Plastic building, black in color

CONSISTS OF:
Center half shafts (3 internal splined and two external splined)

REQUIRES:
Setup on the car

SPECIFICATIONS:
Size: 17.2mm (0.68")

This product compliments the above reviewed product.

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FUNCTIONS:
Fully put together
Plastic telescoping driveshaft with steel universals
Blue rubber boot guards telescoping areas from dirt
Attaches to the differential with one screw pin
Works on the front or rear, right or left of car

CONSISTS OF:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Guideline sheet

REQUIRES:
Setting up on chassis

This product compliments the above reviewed product.

U-Joints, Driveshaft Revo

These are the Drive Shaft Joints for the Traxxas Revo.

FEATURES:
Steel universal joint set

CONSISTS OF:
Four Steel Universal obstructs
Four Steel Universal pins
2 black steel set pins
Four steel hinge pins
Four steel bearing pins
8 1.4mm e-clips

REQUIRES:
Setting up on Traxxas Revo

Get this product to improve the one you are reading around.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for use on the E-Revo

FUNCTIONS:
Stainless Steel bearing building
Blue rubber dirt guards

CONSISTS OF:
(2) 6x13x5mm ball bearings Part #5180

SPECIFICATIONS:
Inside diameter: 6mm (0.24")
Outside diameter: 13mm (0.51")
Width: 5mm (0.20")

Want an additional excellent product to enhance the above stated product?

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Building and construction
Blue and Black in Color

CONSISTS OF:
Four Blue Rubber Pivot Ball Boots
Four Black Dust Boot Retainer
Four Blue Notched Dust Boot Retainer
Four Blue Rubber Boot Plugs
Four nylon Pivot Ball Retainers
Guideline sheet

REQUIRES:
2 bundles needed to finish truck

This product compliments the main item here.

12 X 18 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

    These are the replacement Wheel Hub Ball Bearings for
the Traxxas Nitro Revo Beast Truck.

FEATURES:
Stainless Steel Building and construction
Blue Rubber Sealed

CONSISTS OF:
2 12mm x 18mm Blue Sealed Stainless Wheel Hub Bearings

REQUIRES:
Assembly onto Vehicle

SPECIFICATIONS:
Outer Size: 18mm (0.70")
Inner Size: 12mm (0.47")
Thickness: 4mm (0.15")

COMMENTS:
These are for the Within the Wheel Hubs, the Truck Requires
Four Total of these Bearings.

Get this product to improve the one you are reading around.

Stub Axle Yokes & Pins Revo

This is a set of replacement Drive Yokes for the Traxxas Revo.
These yokes attach to the half shaft assemblies.

FEATURES:
Black plastic building

CONSISTS OF:
2 yokes
2 drive pins

REQUIRES:
Absolutely nothing. These are direct replacement parts.