Traxxas Stub Axles Rear (2)

These are the Rear Stub Axles
for the Traxxas Outlaw, Stampede and Rustler.

FEATURES:
Metal construction, black and silver in color

CONSISTS OF:
2 rear stub axles and pins

SPECS:
Length: 1.65" (42mm)
Size: .51" (13mm) at largest point

Here is another product that praises the product being discussed.

Half Shafts Long Truck (2)

This is a set of telescoping drive shafts for the Blue Eagle LS II.

Includes: 2 white nylon telescoping shaft (each shaft is made from 2 pieces)
4 aluminum U-joints

pcd 01/23/94

Here is another product that praises the product being discussed.

Half Shafts Long Truck (6)

This is a set of the Traxxas telescoping drive shafts (equivalent of dogbones
or swing shafts). These are for use on Traxxas trucks.

Features: White plastic parts

Consists of:
(6) sets of drive shafts (each set includes an inside shaft wich
slides in the outdoors shaft).

Measurements: 2.5" long when totally compressed.

Requires: Absolutely nothing else required

This product is regularly acquired with the above discussed product.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing construction
Blue rubber dirt shields

CONSISTS OF:
(2) 5X11mm ball bearings, Part #5116

SPECS:
Inside diameter: 3/16" (5mm)
Outdoors diameter: 7/16" (11mm)
Width: 5/32" (4mm)

Here is a fantastic product that several others have actually bought at the very same time.

Caster Blocks, For Traxxas Electric Slash, Stampede, Rustler, Ni

These are RPM 30° Front Caster Blocks for the Traxxas
Electric Stampede and Rustler.
These obstructs install to the front A-arms and is exactly what the
steering knuckles connect to.

FEATURES:
Nylon construction, black in color
Stamped right and left to guarantee correct installation

CONSISTS OF:
2 RPM 30° Front Caster Blocks

NEEDS:
Assembly in between A-arms and steering knuckles

The below product likewise pairs really well with the product being discussed.



This is the ST Racing Silver Aluminum Back Center Carrier
for the Traxxas Slash 2WD, Stampede, Rustler and Bandit.

FEATURES:
Silver in color

CONSISTS OF:
One Silver Aluminum Back Center Carrier

Here is a fantastic product that several others have actually bought at the very same time.

Plastic Shock Caps & Bottoms

These are Shock Caps and Bottoms for Traxxas kits.
These seal the shock containing the shock oil.

FEATURES:
Nylon construction

CONSISTS OF:
2 nylon shock cap (tops)
2 nylon shock cap (bottoms)

NEEDS:
Other shock parts

SPECS:
Size Tops Bottoms
16MM 13MM

COMMENTS:
These fit the N/E 4-tec, N/E Stampede, and T/E-Maxx

Numerous others have actually acquired this product in addition to the product that you are currently reviewing.

Stub Axle Carriers (2) (R & S)

This is the Traxxas #3652 Stub Axle Carrier that comes consisted of with
the Rustler and Stampede trucks.

FEATURES:
Made of a black plastic/nylon material.
Also called the rear center or center carrier.
Has 2 possible install places for the external hinge pin shaft.

INCLUDES.
2 Stub alxe carriers.

COMMENTS:
This holds the 2 5x8mm bushings (or bearings) on the stub
axle also called the wheel shaft.

AXY
3/25/95

Here is a fantastic product that several others have actually bought at the very same time.

Diff Output Yokes Bk (2) W/3X5mm Cntrsnk Screws (2 ) &

These are the Differential Output Yokes
for the Traxxas Outlaw, Stampede and Rustler VXL.

FEATURES:
Black plastic construction

CONSISTS OF:
2 differntial output yokes
2 3x5mm countersunk screws
2 screw pins

NEEDS:
Setup

SPECS:
Length: .70" (18mm)
Size: .51" (13mm)