Traxxas Slash 4x4 Platinum SC Racing Truck

This is the brushless electric powered, radio controlled, almost ready to run
1/10 scale Traxxas Slash 4x4 Platinum Edition Short-Course Racing Truck.
The differences between this version and the 6804 are a new Low CG Chassis
and GTR High Volume Shocks on the 6804R.

Needs transmitter, receiver, batteries, battery charger
and paint for the body.

FEATURES:
Chassis: Nylon composite construction 0.08" (2mm) thick tub type
Drive: 4 wheels of chassis
Electronic Speed Control: Traxxas VXL-3S waterproof, with high-
    current adapter, training mode, reverse and low voltage
    detection for use with 2S and THREE LiPo loads
Motor: Traxxas Velineon 3500 with ultra high temperature level
    Neodymium magnets and high speed ball bearings
Spur Gear: 45 tooth
Pinion Gear: 31 tooth 48 pitch, extra pinion gear included for 50+
    MPH operation with extra battery
Body: Clear polycarbonate with overspray movie and window masks
Bumpers: Front and back, composite construction
Shocks: Difficult anodized oil-filled aluminum body GTR with PFTE covered
    13mm bores and titanium nitride shafts for smooth, constant
    damping
Suspension: C-hub design, front and rear sway bars
Transmission: Ball bearing equipped
Differentials: Sealed silicone filled planetary gear type, center
    diff installs trackside in minutes changing the Torque Control
    slipper
Ball Bearings: Rubber sealed
Caster: Non-adjustable
Camber: Adjustable, camber describes the angle of the tops of the
    tires from vertical when seen from front or behind automobile
Tires: Accredited BF Goodrich soft compound Mud Surface T/A 4.3"
    (109mm) diameter, 1.7" (43mm) large
Wheels: 5-spoke brushed chrome, 0.98" (25mm) large, 1.4" (35mm)
    diameter, standard size 12mm hex, aluminum wheel nuts
Steering: Blue anodized aluminum steering blocks, spring packed servo
    defense, high torque digital ball bearing servo

CONSISTS OF:
ARR Traxxas Slash 4x4 Platinum Edition Short-Course Racing Truck with
    steering servo, decals, aluminum C-hubs, steering blocks, rear center
    providers and axle nuts, extra swaybar set, Huge Bore shocks, clear
    body, Velineon 3500 brushless motor and instruction manual

NEEDS:
Radio: 2-channel transmitter with receiver
AA Cells: 8 for transmitter
Battery:
Charger:
Paint: Polycarbonate safe spray or brush-on

SPECS:
Car-
Length: 22.36" (568mm)
Width: 11.65" (296mm)
Height: 8.42" (214mm)
Front and Rear Track: 11.65" (296mm) distance between outer edges of
    wheels side-to-side
Ground Clearance: 2.5"
    Body-
Length: 21.25" (540mm)
Width: 11.5" (292mm)
Height: 5.5" (140mm)

REMARKS:
The ball bearings in the Traxxas Slash 4x4 are rubber closed.
Following are the stock numbers for the replacement bearings from
    Traxxas and non-rubber sealed alternatives from Duratrax;
    Qty. Size Area Qty. Bearing Set
2 8x12mm Fr Drivshaft 1 TRAC7020 DTXC1581
2 4x8mm Fr Hubs 1 TRAC7019 DTXC1511
2 8x12mm Back Drivshaft 1 TRAC7020 DTXC1581
2 4x8mm Rear Hubs 1 TRAC7019 DTXC1511
2 4x8mm Fr Diff 1 TRAC7019 DTXC1511
2 5x8mm Steering Bellcrank 1 TRAC6728 DTXC1523
2 4x7mm Rocker Arm Post 2 DTXC1507
4 8x12mm Differentials 2 TRAC7020 DTXC1581
4 4x8mm Differentials 2 TRAC7019 DTXC1511
6 4x8mm Transmission 3 TRAC7019 DTXC1511
2 4x8mm Rear Ring Gear 1 TRAC7019 DTXC1511