Traxxas Nuts, 4Mm Flanged Locking Serrated- Aluminum Green

This is a plan of 4 4mm Flanged Locknuts in Green from Traxxas.

FEATURES:
May be used in any application needing this size locknut
Serrated rear section ensures sure grip

CONSISTS OF:
Four 4mm Flanged Locknuts

REQUIRES:
7mm Nut Motorist

SPECIFICATIONS:
Hex Size: 7mm
Hole Diameter: 4mm

Want an additional fantastic item to enhance the above stated item?

4Mm Alum Flanged Nylock Nuts Blue (4)

These are the 4mm Flanged Nylon Locknuts from Traxxas.

FEATURES:
Aluminum construction anodized blue in color
Serrated on the back for sure grip

CONSISTS OF:
Four 4mm Flanged Nylon Locknuts

REQUIRES:
6mm nut motorist

SPECIFICATIONS:
Hole Diameter: 4mm
Hex Size: 6mm

This is a amazing addition to the item currently being discussed.

CNC Mach Alum Lock-Pin Hex Adapter Stampede

This is the 12mm Lock-Pin Type Hex Center from ST Racing
For the Traxxas Electric Stampede, Rustler, Bandit, Slash
and Nitro Slash.

FEATURES:
Using high quality CNC machined aluminum, these Lock-pin design alum.
wheel hex locks down on the axle pins so loosing pins are no longer a
problem for your Traxxas electric Stampede/Rustler/Bandit or the new
Slash. Aluminum hex are likewise more resilient and less likely to strip
out and supplies a much better fit to the wheel hex.

These are blue in color.

INCLUDES:
Four hex hubs
One 1.5mm Allen L-wrench

SPECIFICATIONS:
Width: 12mm (15/32")
Density: 6mm (5/16")
Diameter, hole: 5.5mm (7/32")

REMARKS:
These adapters can be installed on
Traxxas Stampede (TRAC23** & TRAD14**)
Traxxas Rustler (TRAC14**)
Traxxas Slash (TRAD19** & TRAD27**)
Traxxas Bandit (TRAD13**)
Traxxas Nitro Slash (TRAD77**)

Several others have actually gotten this item along with the item that you are currently checking out.

14T Pinion Gear 32P

This is a 14 Tooth 32 Pitch Pinion Gear for the Traxxas E-Maxx Truck.
This is the gear which is connected directly to the motor.

FEATURES:
Machined Steel
Created for a 3mm shaft

CONSISTS OF:
One 14 tooth Pinion Gear
One 3 x 4mm Set Screw

REQUIRES:
Assembly onto an E-Maxx truck.
1.5mm hex wrench to tighten up set screw.

COMMENTS:
This gear is just one of 2 which are used on the E-Maxx dual motor
    set-up.

Several others have actually gotten this item along with the item that you are currently checking out.

Diff Ring Gear / Pinion Gear Revo

This is the Differential Ring Gear and Pinion
for usage with the Traxxas Revo 3.3.

FEATURES:
Direct replacement part

CONSISTS OF:
One differential ring gear
One pinion gear

REQUIRES:
Traxxas Revo 3.3
2.5x8mm cap head screws (TRAC3965)