Traxxas T Maxx .15 To 2.5 Upgrade Kit

This is the Pro .15 to TRX 2.5 engine conversion set from Traxxas.
It allows you to install the newer 2.5 engine to an older T-Maxx.

FUNCTIONS:
Tuned pipeline, bellcrank, & throttle servo horn made from plastic
Linkage wire made from steel

CONSISTS OF:
One Plastic Tune Pipe w/Wire Hanger (TRAG5152)
One Exhaust Header w/Screws & O-ring (TRAG5140)
One Exhaust Coupler (TRAG5246)
One Slide Carb Link Bellcrank (TRAC5167)
One Slide Carb Linkage Set (TRAC5168)
One Drill Bit for drilling Bellcrank Post mounting holes
2 Tie-Straps for mounting Exhaust Coupler
One 90-degree pressure fitting
One 3x10mm machine cap screw w/washer
One guideline sheet
One drilling design template sheet

NEEDS:
2.5 engine stock clutch system and stock engine install

SPECIFICATIONS:
Tune Pipe Length: 101.6mm (4")
Header Pipe Outer Diameter: 13mm (.51")
Drill Bit size: 3.175mm (.125")

COMMENTS:
If EZ Start system is required, utilize TRAP5271

You will certainly love this product if you have the product just above pointed out.

3.3 Engine Ips Shaft W/Pull Start

This is the Traxxas TRX 3.3 Racing Engine with Pull Starter.

FEATURES:
For usage in all Traxxas TRX2.5 and TRX 3.3 equipped cars
Pull starter can be eliminated to set up the EZ Start
60% more peak power than the TRX2.5, with almost 50% more power
    under the curve for strong linear velocity
Round rear exhaust with one-piece IPS crankshaft
Composite body slide valve carburetor with high-volume air filter
Blue anodized aluminum cooling head with molded head protector

CONSISTS OF:
Traxxas TRX 3.3 Racing Engine with Pull Starter and radiance plug
One guideline manual (TRAZ5300)
One service assistance guide and parts lis.
One set of engine decals
One engine burglary DVD
One little bottle of air filter oil
One air filter

NEEDS:
Vehicle fuel with 10%, 20% or 33% nitro content

SPECIFICATIONS:
Displacement: .20 cu in (3.3cc)
Practical RPM: N/A
Output: N/A
Weight: 10.9oz (305g)
Distance between mounting holes very same side: 0.39" (10mm)
Distance between mounting holes opposite side: 1.2" (32mm)
Distance from center of engine to front bearing: 1.2" (32mm)
Distance/bottom of mounting flanges/top of cylinder head: 3.5" (88mm
Width of mounting flanges: 44mm

COMMENTS:
Other versions of the TRX 3.3 engine consist of;
    #5404 Single Shaft without Starter, TRAG5404
    #5406 Multi-Shaft without Starter, TRAG5406
    #5409 Multi-Shaft w/Recoil Pull Starter, TRAG5409