Traxxas Latrax 1/18 Teton Monster Truck 4Wd Rtr, W/ 2.4Ghz Radio, Batter

This is the Electric Powered, 2.4GHz Radio Controlled, 1/18 scale,
Ready to Run LaTrax Teton Beast Truck from Traxxas.

FEATURES:
Chassis: Molded composite nylon monocoque
Drive: Four wheel, steel center driveshaft
Differentials: Solidified steel bevel equipment
Radio: 2.4GHz with 3-channel micro receiver, water resistant guiding
    servo, and all weather electronics that permit owning through
    puddles, ice, slush, and more
Electronic Speed Control: Fully proportional forward, brake, reverse,
    programmable with three drive profiles, Sport, Race and Training
    Mode, two-stage low-voltage detection for optional LiPo battery,
    water resistant under typical usage
Motor: 370 size brushed
Battery: 2/3A 6-cell, 7.2V, 1200mAh NiMH, with iD connector
Battery Charger: AC powered
Suspension: Fully independent
Shocks: Oil filled plastic body, coil over
Body: ProGraphix Fully painted with decals applied
Steering: Two bellcranks on chassis to increase the speed of the
    servo, and supply precise geometry for the guiding angle of each
    wheel
Ball Bearings: Complete set consisted of
Front and Rear Bumpers: Plastic
Tires: Rubber, off-road tread
Wheels: 5 spoke 1.63" (41mm) size

CONSISTS OF:
RTR LaTrax Teton Beast Truck, with Motor, 2.4GHz Radio, ESC, NiMH
    Battery, Charger, 4 AA Batteries, User's manual, 10T Pinion
    Gear, 60T Spur Gear

SPECS:
Lorry;
Length: 10.16" (258mm)
Front Track: 4.17" (106mm)
Rear Track: 4.23" (107.5mm)
Weight: 19.2oz (55g) with battery
Weight: 13.3oz (43g) without battery
Height: 4.65" (118mm)
Wheelbase: 6.44" (163.5mm)
Shock Length: 2.36" (60mm)
Ground Clearance: 1.18" (30mm)
Internal Gear Ratio: 2.5:1
Overall Drive Ratio: 15:1 stock
Gear Pitch: 0.5 Mod
Battery Tray Dimensions: 4 x 1.4 x 0.71" (102 x 35 x 18mm)
    Body;
Length: 9.4" (239mm)
Width: 3.6" (91mm)
Height: 3.3" (84mm)

REMARKS:
Readily available in the following body colors;
    Blue, TRAD22BB
    Green, TRAD22GG
    Orange, TRAD22NN
    Red, TRAD22RR

If replacement ball bearings are required, Traxxas uses the
    7541X, Latrax Ball Bearing Set TRAC9804, that changes all the
    ball bearings.