Traxxas U-Joints, Driveshaft Revo

These are the Drive Shaft Joints for the Traxxas Revo.

FEATURES:
Steel universal joint set

CONSISTS OF:
Four Steel Universal blocks
Four Steel Universal pins
2 black steel set pins
Four steel hinge pins
Four steel bearing pins
Eight 1.4mm e-clips

REQUIRES:
Setting up on Traxxas Revo

Right here is an additional item that praises the item being gone over.

Yokes Diff/Tranny

These are the Diff and Trans Drive Yokes for the Traxxas T-Maxx 3.3. TRAC78**

FUNCTIONS:
Black plastic building

CONSISTS OF:
2 drive yokes
2 4x15mm Yoke pins

REQUIRES:
T-Maxx 3.3

SPECS:
Length: 15/16" (23mm)
Diameter: 3/4" (17mm)

Want an additional terrific item to match the above mentioned item?

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FUNCTIONS:
Fully put together
Plastic telescoping driveshaft with steel universals
Blue rubber boot guards telescoping areas from dirt
Connects to the differential with one screw pin
Works on the front or rear, right or left of vehicle

CONSISTS OF:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Instruction sheet

REQUIRES:
Setting up on chassis

This item praises the main item below.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for usage on the E-Revo

FUNCTIONS:
Stainless-steel bearing building
Blue rubber dirt guards

CONSISTS OF:
(2) 6x13x5mm ball bearings Part #5180

SPECS:
Inside size: 6mm (0.24")
Outdoors size: 13mm (0.51")
Width: 5mm (0.20")

This item praises the above gone over item.

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Construction
Blue and Black in Color

CONSISTS OF:
Four Blue Rubber Pivot Ball Boots
Four Black Dust Boot Retainer
Four Blue Notched Dust Boot Retainer
Four Blue Rubber Boot Plugs
Four nylon Pivot Ball Retainers
Instruction sheet

REQUIRES:
2 packages needed to finish truck

Numerous others have acquired this item in addition to the item that you are presently checking out.

Center Half Shafts E-Revo

This is the Center Half Shaft Set for the Traxxas E-Revo

FUNCTIONS:
Plastic building, black in color

CONSISTS OF:
Center half shafts (3 internal splined and two external splined)

REQUIRES:
Installation on the vehicle

SPECS:
Diameter: 17.2mm (0.68")

Get this item to boost the one you read around.

12 X 18 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

    These are the replacement Wheel Center Ball Bearings for
the Traxxas Nitro Revo Monster Truck.

FEATURES:
Stainless-steel Construction
Blue Rubber Sealed

CONSISTS OF:
2 12mm x 18mm Blue Sealed Stainless Wheel Center Bearings

REQUIRES:
Assembly onto Vehicle

SPECS:
Outer Diameter: 18mm (0.70")
Inner Diameter: 12mm (0.47")
Density: 4mm (0.15")

REMARKS:
These are for the Inside of the Wheel Centers, the Truck Needs
Four Total of these Bearings.

This is a amazing enhancement to the item presently being gone over.

Axle Carriers Use Larger 6 X 1

These are the Optional Axle Carriers L & R for
usage on the Traxxas Revo series.

FEATURES:
Nylon Construction
Black in Color
Enables Oversized Bearing utilize

CONSISTS OF:
One Left Axle Carrier
One Right Axle Carrier
Four Dust Boot Retainers
2 Bearing Spacers

REQUIRES:
Installation