Traxxas Xo-1 Connector Power Tab

This is the Power Tap Connector for the Traxxas XO-1, TRAD42**.

FUNCTIONS:
Changes busted power tap ports

CONSISTS OF:
Connector with Wire and Red 2-Pin Connector and Zip Tie

This product compliments the main item below.

Telemtry Trigger Magnet Holder Spur Gear/Magnet

These are the Traxxas Telemetry Trigger Magnet Holders,
Stimulate Gear/Telemetry Trigger Magnet

FUNCTIONS:
Black plastic and metal building and construction

CONSISTS OF:
2 various plasting holders
One disk-shaped magnet
Three 8mm screws
Three 10mm screws

SPECS:
Magnet diameter: 5mm
Magnet density: 2mm

The listed below product likewise pairs really well with the product being gone over.

Mount, Temp Sensor (Electric Motors)-Wire Tie/Thermal Pad

This is the Temperature Sensor Mount for the Traxxas TQi Telemetry System.

FEATURES:
For usage with electrical powered Traxxas automobiles

CONSISTS OF:
Mount, Plastic Tie, and Thermal Pad

This is a amazing enhancement to the product presently being gone over.

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FUNCTIONS:
Totally put together
Plastic telescoping driveshaft with steel universals
Blue rubber boot guards telescoping sections from dirt
Attaches to the differential with one screw pin
Works on the front or rear, right or left of car

CONSISTS OF:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Instruction sheet

NEEDS:
Installing on chassis

You will enjoy this thing if you have the thing above mentioned.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for usage on the E-Revo

FUNCTIONS:
Stainless Steel bearing building and construction
Blue rubber dirt guards

CONSISTS OF:
(2) 6x13x5mm ball bearings Part #5180

SPECS:
Inside diameter: 6mm (0.24")
Outside diameter: 13mm (0.51")
Width: 5mm (0.20")

Want one more terrific product to enhance the above discussed product?

Sensor Temperature/Voltage Short

This is the Brief Temperature and Voltage Sensor from Traxxas.

FEATURES:
Functions with the Traxxas Link system to show battery voltage and
    temperature

CONSISTS OF:
Brief Temperature and Voltage Sensor

SPECS:
Length: 9.5" (241mm)

This is a amazing enhancement to the product presently being gone over.



These are Male 2-Pin Flat Red Connectors with 3" wires.
This is also referred to as a JST connector.

FEATURES:
Designed for usage with a lot of Park Flyer ElectriFly electronics
Red 2-pin flat connector is a BEC-style
Wires are 24 gauge and pre-tinned at ends for simple soldering
One year quality assurance

CONSISTS OF:
2 Male 2-Pin Red Connectors with 3" wires

NEEDS:
Soldering to connect wires to application

SPECS:
Plug Size-
    Length: 13mm (total with flanges)
    Width: 5.5mm
    Height: 3mm

REMARKS:
For the female ports with wire, usage GPMM3107
This connector can be utilized to replace BEC-type ports.

You will enjoy this thing if you have the thing above mentioned.

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Building
Blue and Black in Color

CONSISTS OF:
4 Blue Rubber Pivot Ball Boots
4 Black Dust Boot Retainer
4 Blue Notched Dust Boot Retainer
4 Blue Rubber Boot Plugs
4 nylon Pivot Ball Retainers
Instruction sheet

NEEDS:
2 plans had to finish truck