Traxxas Center Half Shafts E-Revo

This is the Center Half Shaft Set for the Traxxas E-Revo

FEATURES:
Plastic building, black in color

CONSISTS OF:
Center half shafts (three internal splined and 2 external splined)

REQUIRES:
Setup on the vehicle

SPECIFICATIONS:
Size: 17.2mm (0.68")

Get this thing to improve the one you are reading around.

Yokes Diff/Tranny

These are the Diff and Trans Drive Yokes for the Traxxas T-Maxx 3.3. TRAC78**

FEATURES:
Black plastic building

CONSISTS OF:
2 drive yokes
2 4x15mm Yoke pins

REQUIRES:
T-Maxx 3.3

SPECIFICATIONS:
Length: 15/16" (23mm)
Size: 3/4" (17mm)

This thing praises the above discussed thing.

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FEATURES:
Fully put together
Plastic telescoping driveshaft with steel universals
Blue rubber boot guards telescoping areas from dirt
Attaches to the differential with one screw pin
Works on the front or rear, right or left of vehicle

CONSISTS OF:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Instruction sheet

REQUIRES:
Installing on chassis

Lots of others have acquired this thing together with the thing that you are presently reviewing.

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing building
Blue rubber dirt guards

CONSISTS OF:
(2) 5X11mm ball bearings, Part #5116

SPECIFICATIONS:
Inside diameter: 3/16" (5mm)
Outside diameter: 7/16" (11mm)
Width: 5/32" (4mm)

Lots of others have acquired this thing together with the thing that you are presently reviewing.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for use on the E-Revo

FEATURES:
Stainless-steel bearing building
Blue rubber dirt guards

CONSISTS OF:
(2) 6x13x5mm ball bearings Part #5180

SPECIFICATIONS:
Inside diameter: 6mm (0.24")
Outside diameter: 13mm (0.51")
Width: 5mm (0.20")

Get this thing to improve the one you are reading around.

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Construction
Blue and Black in Color

CONSISTS OF:
Four Blue Rubber Pivot Ball Boots
Four Black Dust Boot Retainer
Four Blue Notched Dust Boot Retainer
Four Blue Rubber Boot Plugs
Four nylon Pivot Ball Retainers
Instruction sheet

REQUIRES:
2 packages needed to finish truck

This thing praises the above discussed thing.

U-Joints, Driveshaft Revo

These are the Drive Shaft Joints for the Traxxas Revo.

FEATURES:
Steel universal joint set

CONSISTS OF:
Four Steel Universal obstructs
Four Steel Universal pins
2 black steel set pins
Four steel hinge pins
Four steel bearing pins
8 1.4mm e-clips

REQUIRES:
Installing on Traxxas Revo

You will certainly enjoy this thing if you have the thing previously stated.

Driveshaft Boots (2) Revo

These are the replacement Drive Shaft Boots for
the Traxxas Nitro Revo Beast Truck.

FEATURES:
Rubber Construction
Blue in Color

CONSISTS OF:
2 Blue Rubber Driveshaft Boots

REQUIRES:
Assembly onto Automobile

Want another wonderful thing to compliment the above discussed thing?

Skid Plate Set Front & Rear Revo Summit

This is the Front and Rear Skid Plates for the Traxxas Revo.

FEATURES:
Black plastic building
Front skid plate is a two-piece design
Rear skid plate is a one-piece design

CONSISTS OF:
Front and check out skid plates Part #5337
(8) 3X10mm button head screws Part #2577
(1) 3X30mm button head screws Part #2582

REQUIRES:
Setup on the Traxxas Revo