Traxxas 4-Cell Battery Holder Assembly (No On/Off Switch - Use W/Mal

This is the 4C Battery Holder w/Futaba Port
for the Traxxas Nitro Jato Stadium Truck.

FEATURES:
Nylon building and construction
Black in color

CONSISTS OF:
One 4 cell AA Battery Holder w/Futaba Port

REQUIRES:
Assembly onto Vehicle

Here is a terrific product that several others have purchased the same time.

Wiring Harness For Rx Power Pack, Nitro Vehicles W Ith On/

This is an optional Receiver Change Harness with Charge Jack for all
Traxxas Nitro Cars other than for the Traxxas Revo.

FEATURES:
Futaba J plugs
Pre-installed receiver pack charge lead

CONSISTS OF:
One put together switch harness

REQUIRES:
Setup into vehicle.

SPECS:
Receiver lead length: 313mm
Charge jack lead length: 100mm
Battery connector lead: 147mm

COMMENTS:
This will likewise work on most other nitro applications. The only
    distinction between this and TRAM3035 is the lead lengths and the
    switch faceplate design.

This product is often purchased with the above stated product.

Wiring Harness For On-Board Radio System (W/ On/Of F Switc

This is the On/Off Change Harness
for the Traxxas Nitro Jato Stadium Truck.

FEATURES:
Plastic building and construction
Black in color
Futaba typecConnectors

CONSISTS OF:
One On/Off Change Harness w/Charge Cord.

REQUIRES:
Assembly onto Vehicle

The below product also pairs truly well with the product being gone over.



This is a Variety of Heat Shrink Tubing from Dubro.

FEATURES:
Created to diminish up to 1/2 of its original size
Ideal for insulating electrical splices, covering electrical plugs
and adapters
Assorted colors for easy reference

CONSISTS OF:
Twelve (12) assorted sizes and colors of heat diminish tubing

REQUIRES:
Diminish tubing on all sides with heat gun, butane lighter or soldering
iron

SPECIFICATIONS:
Length: 3"
Diameter: 2 each: 1/16", 3/32", 1/8", 3/16", 1/4", and 3/8".

COMMENTS:
Select a tubing size that is no more than two times the diameter of the
item that is being covered