Traxxas Axle Carriers Use Larger 6 X 1

These are the Optional Axle Carriers L & R for
usage on the Traxxas Revo series.

FEATURES:
Nylon Construction
Black in Color
Permits Oversized Bearing utilize

CONSISTS OF:
One Left Axle Carrier
One Right Axle Carrier
4 Dust Boot Retainers
Two Bearing Spacers

REQUIRES:
Installation

Right here is a great item that many others have bought at the exact same time.

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Construction
Blue and Black in Color

CONSISTS OF:
4 Blue Rubber Pivot Ball Boots
4 Black Dust Boot Retainer
4 Blue Notched Dust Boot Retainer
4 Blue Rubber Boot Plugs
4 nylon Pivot Ball Retainers
Instruction sheet

REQUIRES:
Two packages needed to finish truck

Get this item to enhance the one you are reading around.

12 X 18 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

    These are the replacement Wheel Center Ball Bearings for
the Traxxas Nitro Revo Beast Truck.

FEATURES:
Stainless Steel Construction
Blue Rubber Sealed

CONSISTS OF:
Two 12mm x 18mm Blue Sealed Stainless Wheel Center Bearings

REQUIRES:
Assembly onto Vehicle

SPECS:
Outer Size: 18mm (0.70")
Inner Size: 12mm (0.47")
Density: 4mm (0.15")

COMMENTS:
These are for the Inside of the Wheel Hubs, the Truck Requires
4 Overall of these Bearings.

Get this item to enhance the one you are reading around.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for usage on the E-Revo

FUNCTIONS:
Stainless Steel bearing building and construction
Blue rubber dirt guards

CONSISTS OF:
(2) 6x13x5mm ball bearings Part #5180

SPECS:
Inside size: 6mm (0.24")
Outdoors size: 13mm (0.51")
Width: 5mm (0.20")

Want one more great item to compliment the above mentioned item?

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FUNCTIONS:
Totally put together
Plastic telescoping driveshaft with steel universals
Blue rubber boot guards telescoping sections from dirt
Attaches to the differential with one screw pin
Functions on the front or rear, right or left of automobile

CONSISTS OF:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Instruction sheet

REQUIRES:
Installing on chassis

Several others have bought this item in addition to the item that you are currently reading about.

Yokes Diff/Tranny

These are the Diff and Trans Drive Yokes for the Traxxas T-Maxx 3.3. TRAC78**

FUNCTIONS:
Black plastic building and construction

CONSISTS OF:
Two drive yokes
Two 4x15mm Yoke pins

REQUIRES:
T-Maxx 3.3

SPECS:
Length: 15/16" (23mm)
Size: 3/4" (17mm)

The below item also sets actually well with the item being gone over.

Pivot Balls W/Cap

These are the Pivot Balls and Pivot Ball Cap Bushings for the
Traxxas T-Maxx and E-Maxx 4WD Radio Control Beast Trucks.
Two of these pivot balls fit into the axle providers at each wheel
    The pivot ball cap bushings fit between the pivot balls
and the aluminum caps.

FEATURES:
Replaces stock pivot balls and pivot ball cap bushings.
Pivot balls are made from steel, pivot ball cap bushings are made from
    plastic.

INCLUDES:
4 pivot balls.
Four pivot ball cap bushings

REQUIRES:
Threading the pivot balls through the axle providers and into the
    suspension arms. Putting pivot ball cap bushings between the pivot
    balls and aluminum caps.