Traxxas Axle Carriers Use Larger 6 X 1

These are the Optional Axle Carriers L & R for
usage on the Traxxas Revo series.

FEATURES:
Nylon Building and construction
Black in Color
Allows for Oversized Bearing use

INCLUDES:
One Left Axle Carrier
One Right Axle Carrier
Four Dust Boot Retainers
2 Bearing Spacers

REQUIRES:
Setup

Right here is a fantastic product that numerous others have bought at the very same time.

Pivot Ball Caps & Dust Boots

This is the replacement Pivot Ball and Dust Cap Boot Set
    for the Traxxas Revo, E-Revo and T-Maxx 3.3 vehicles.

FEATURES:
Nylon and Rubber Building and construction
Blue and Black in Color

INCLUDES:
Four Blue Rubber Pivot Ball Boots
Four Black Dust Boot Retainer
Four Blue Notched Dust Boot Retainer
Four Blue Rubber Boot Plugs
Four nylon Pivot Ball Retainers
Guideline sheet

REQUIRES:
2 bundles needed to finish truck

Get this product to improve the one you are reading about.

12 X 18 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

    These are the replacement Wheel Center Ball Bearings for
the Traxxas Nitro Revo Beast Truck.

FEATURES:
Stainless-steel Building and construction
Blue Rubber Sealed

INCLUDES:
2 12mm x 18mm Blue Sealed Stainless Wheel Center Bearings

REQUIRES:
Assembly onto Car

SPECIFICATIONS:
Outer Diameter: 18mm (0.70")
Inner Diameter: 12mm (0.47")
Thickness: 4mm (0.15")

COMMENTS:
These are for the Inside of the Wheel Centers, the Truck Needs
Four Overall of these Bearings.

Get this product to improve the one you are reading about.

Bbs Blue Rubber Sealed 6 X 13M

This is a set of Traxxas 6x13x5mm Ball Bearings
for usage on the E-Revo

FUNCTIONS:
Stainless-steel bearing building and construction
Blue rubber dirt guards

INCLUDES:
(2) 6x13x5mm ball bearings Part #5180

SPECIFICATIONS:
Inside diameter: 6mm (0.24")
Outdoors diameter: 13mm (0.51")
Width: 5mm (0.20")

Want an additional fantastic product to enhance the above stated product?

Driveshaft Assembly (1)

This is the Driveshaft Assembly for the Traxxas Revo 3.3.
and the T-Maxx 3.3.

FUNCTIONS:
Completely put together
Plastic telescoping driveshaft with steel universals
Blue rubber boot guards telescoping sections from dirt
Connects to the differential with one screw pin
Functions on the front or rear, right or left of automobile

INCLUDES:
#5458X Yoke, TRAC9798
#5145 Screw Pin, TRAC5145
#5450 Halfshaft, TRAC7450
#5452 U Joint, TRAC7452
#5459 Rubber Boot, TRAC7459
Guideline sheet

REQUIRES:
Installing on chassis

Numerous others have purchased this product together with the product that you are currently reviewing.

Yokes Diff/Tranny

These are the Diff and Trans Drive Yokes for the Traxxas T-Maxx 3.3. TRAC78**

FUNCTIONS:
Black plastic building and construction

INCLUDES:
2 drive yokes
2 4x15mm Yoke pins

REQUIRES:
T-Maxx 3.3

SPECIFICATIONS:
Length: 15/16" (23mm)
Diameter: 3/4" (17mm)

The below product likewise sets actually well with the product being talked about.

Pivot Balls W/Cap

These are the Pivot Balls and Pivot Ball Cap Bushings for the
Traxxas T-Maxx and E-Maxx 4WD Radio Control Beast Trucks.
Two of these pivot balls suit the axle providers at each wheel
    The pivot ball cap bushings fit between the pivot balls
and the aluminum caps.

FEATURES:
Changes stock pivot balls and pivot ball cap bushings.
Pivot balls are made from steel, pivot ball cap bushings are made from
    plastic.

INCLUDES:
Four pivot balls.
Four pivot ball cap bushings

REQUIRES:
Threading the pivot balls through the axle providers and into the
    suspension arms. Putting pivot ball cap bushings between the pivot
    balls and aluminum caps.