JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.

Traxxas Adapter Traxxas ID LiPo Battery (Traxxas 2938 | TRA2938)
Due to the impact of the COVID-19/Corona virus, there my be delays in the shipping estimates shown on our site.

We appreciate your understanding and support during these uncertain times.

Model: Traxxas 2938
Dist. #: TRA2938   SKU: TRA2938

Be the first to review this product. (Write Review)

Out of stock

Price:  $11.99

This item will earn you 12 reward point(s).
12 points = $0.24 off your next order. Learn More

Updated on Jan 24, 2022 01:23:01 AM

Adapter Traxxas ID LiPo Battery...
This is the Traxxas iD LiPo Battery Adapter.

FEATURES:
Links Traxxas iD LiPo batteries to LiPo chargers with different
    balance ports

SUCHES AS:
iD LiPo Battery Adapter with 3S Balance Port
Adapter with TWO Balance Port

SPECS:
Length: 5.2" (132mm) including ports

Below is one more item that compliments the item being gone over.

8400Mah 11.1V 3-Cell 25C Lipo

This is the Traxxas Power Cell 11.1V 8400mAh 25C 3S LiPo Battery.

FEATURES:
Semi stiff building does not require a hard case and removes
    wire harness ports that can loosen and fail
Engineered specifically to fit Traxxas designs
12AWG multi hair wire is soldered directly to the LiPo cells
    eliminating increased resistance from bullet ports and
    unexpected reversed polarity connections

SUCHES AS:
Traxxas Power Cell 11.1V 8400mAh 25C LiPo 3S Battery with High
    Existing Port and JST/XH Balance Plug

NEEDS:
Balancer and LiPo compatible charger or LiPo charger with built-in
    balancer such as the Onyx 235, DTXP4235
LiPo charging bag

SPECS:
Configuration: 3S2P
Continuous Discharge: 25C (210A)
Max Burst Rate: 50C (420A)
Watt Hours: 93.24
Charge Rate: 1C (8.4A)
Max Charge Rate: 2C (16.8A)
Measurements: 6.1 x 1.7 x 1.8" (155 x 44 x 45mm)
Weight: 21.7oz (615g)

REMARKS:
ALWAYS use a LiPo-approved Charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER Charge through the "To ESC or "DISCHARGE" lead
NEVER EVER Trickle Charge
NEVER enable to Release listed below 2.5V per cell
NEVER take apart or customize pack wiring in any method or puncture cells
NEVER put on combustible materials or leave ignored during
    charging
ALWAYS Charge in a fireproof location
ALWAYS set charger's output volts to match battery volts
CONSTANTLY stay out of reach of kids

Below is one more item that compliments the item being gone over.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Innovative New Features Include;

**Special Self-Righting Action, if vehicle rolls upside down**
**simply press a button on the transmitter and in most cases**
**the X-Maxx will flip upright onto its wheels.**

**One handed body mount and elimination system**
**removes body posts and pins.**

**Battery Retention System removes body clips or hook and loop straps**

**Shock towers likewise serve as carrying manages and level supports**
    **when vehicle is positioned upside down for maintenance.**

**Added Technical Information Will Be Added When It Becomes Available.**

FEATURES:
Traxxas Stability Management (TSM): Superior tuning algorithms operate on
    high-speed electronic parts to manage wheel spin and steering
    instructions on loose dirt, concrete and even ice and snow. TSM can be
    fine tuned or switched off by changing the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design supplies easy access
    to important parts, lower front and rear skids and integrated
    nerf bars for front, rear and side impact defense
Drive Four wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that get rid of axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design removes flexing, keyed pins lock equipment
    mesh in restaurant
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry ready
    receiver, BEC voltage and motor temperature sensing units installed,
    self righting button, built-in fail safe,
    can be geared up with the TQi Docking Base together with the iPhone,
    iPad or iPod touch* to produce a graphical user interface for the
    vehicle Traxxas Link TQi Wireless Module needed (not suched as)
Guiding Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo compatible
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, restricted slip
Slipper Clutch: Dual fan cooled
Battery Retention System: Integrated into chassis top brace for
    higher rigidness, removes body clips or hook and loop straps,
    adjustable for various batteries
Body: ProGraphix painted and cut
Body Mount System: Quick one-hand body installation and elimination,
    rotating rear lock system removes body posts and clips
Suspension: Caught high-strength steel pins, double large
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean reducing seal wear
Shock Towers: Composite plastic building, likewise serve as carrying
    manages and level supports when vehicle is positioned upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with impact cushions
    behind each bumper to soften blows and add to durability
Ball Bearings: Sealed, complete contact
Radio Box: Waterproof

SUCHES AS:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Upkeep Tools

NEEDS:
Batteries: 2 3S LiPo 5000mAh or higher
Battery Charger: Compatible with picked LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECS:
Car;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) distance from external edges of wheels
    measured side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1pounds (8.66kg)
Ride Height: 13.79" (350mm)
Overall Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

REMARKS:
Offered in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings use:
    Qty. Size Area Qty. Bearing Set

Frequently Bought Together

Traxxas Adapter Traxxas ID LiPo Battery
+
Traxxas 8400Mah 11.1V 3-Cell 25C Lipo
+
Traxxas Charge Lead
This Item: Traxxas Adapter Traxxas ID LiPo Battery
$11.99
Traxxas 8400Mah 11.1V 3-Cell 25C Lipo
$129.95
Traxxas Charge Lead
$6.49

Total Price: $148.43

Add All Three To Cart

Customers who bought this product also purchased

Visual Parts Finder
";