Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C 3S LiPo Battery.

FEATURES:
Semi stiff building and construction does not need a hard case and eliminates
    wire harness adapters that can loosen up and fail
Engineered particularly to fit Traxxas designs
New high existing adapter with gold-plated copper terminals and
    integrated balance adapter
iD Automobile Battery Recognition permits Traxxas iD equipped chargers to
    automatically set and enhance charge settings for particular battery
MAXX cable television high-efficiency 12 gauge silicone jacketed wire

SUCHES AS:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo 3S Battery with High
    Current Adapter and Integrated Balance Plug

NEEDS:
LiPo suitable battery charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECIFICATIONS:
Configuration: 3S1P
Continuous Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

REMARKS:
ALWAYS use a LiPo-approved Charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER EVER Trickle Charge
NEVER permit to Discharge below 2.5V per cell
NEVER dismantle or customize pack electrical wiring in any way or leak cells
NEVER place on combustible products or leave unattended throughout
    charging
ALWAYS Charge in a fire-resistant location
ALWAYS set battery charger's output volts to match battery volts
ALWAYS stay out of reach of kids

Below is an additional item that praises the item being discussed.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the Air Conditioning Powered Traxxas EZ-Peak 100W Dual Battery Charger
with iD Automobile Battery Identification.

FEATURES:
Charges 2S and 3S LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD technology automatically sets up and optimizes charge
    settings for Traxxas iD equipped batteries
Charges 2 batteries simultaneously at as much as 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the very same time
Advanced Mode for full manual control of battery charger settings
Development bar and audible informs
Storage Mode prepares LiPo batteries for prolonged storage
One Month limited warranty through Traxxas beginning at date of
    purchase

SUCHES AS:
Traxxas EZ-Peak 100W Dual Battery Charger with Air Conditioning Power Cable,
    Instructions, Cooling Fan

SPECIFICATIONS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (double mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Current Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Dimensions: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This item is often bought with the above stated item.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Features Include;

**Unique Self-Righting Action, if car rolls upside down**
**simply push a button on the transmitter and in many cases**
**the X-Maxx will turn upright onto its wheels.**

**One handed body install and elimination system**
**eliminates body posts and pins.**

**Battery Retention System eliminates body clips or hook and loop straps**

**Shock towers likewise work as carrying deals with and level supports**
    **when car is put upside down for upkeep.**

**Additional Technical Information Will Be Added When It Appears.**

FUNCTIONS:
Traxxas Stability Management (TSM): Superior tuning algorithms run on
    high-speed electronic parts to control wheel spin and steering
    instructions on loose dirt, concrete as well as ice and snow. TSM can be
    tweaked or switched off by changing the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design provides easy access
    to vital parts, lower front and rear skids and integrated
    nerf bars for front, rear and side effect protection
Drive 4 wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that remove axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design eliminates flexing, keyed pins lock equipment
    mesh in place
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry ready
    receiver, BEC voltage and motor temperature sensing units installed,
    self righting button, built-in fail safe,
    can be equipped with the TQi Docking Base in addition to the iPhone,
    iPad or iPod touch* to produce a graphical user interface for the
    car Traxxas Link TQi Wireless Module needed (not suched as)
Guiding Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo suitable
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, limited slip
Slipper Clutch: Dual fan cooled
Battery Retention System: Integrated into chassis leading brace for
    higher rigidness, eliminates body clips or hook and loop straps,
    adjustable for different batteries
Body: ProGraphix painted and trimmed
Body Mount System: Quick one-hand body setup and elimination,
    pivoting rear latch mechanism eliminates body posts and clips
Suspension: Recorded high-strength steel pins, double large
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean minimizing seal wear
Shock Towers: Composite plastic building and construction, likewise work as carrying
    deals with and level supports when car is put upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with effect cushions
    behind each bumper to soften blows and contribute to durability
Ball Bearings: Sealed, full contact
Radio Box: Waterproof

SUCHES AS:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Upkeep Tools

NEEDS:
Batteries: Two 3S LiPo 5000mAh or higher
Battery Charger: Suitable with selected LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECIFICATIONS:
Automobile;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) distance from external edges of wheels
    determined side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1pounds (8.66kg)
Ride Height: 13.79" (350mm)
Total Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

REMARKS:
Readily available in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings usage:
    Qty. Size Place Qty. Bearing Set