Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C 3S LiPo Battery.

FEATURES:
Semi rigid construction does not require a tough case and removes
    wire harness adapters that can loosen and fail
Engineered specifically to fit Traxxas models
New high existing port with gold-plated copper terminals and
    incorporated balance port
iD Auto Battery Identification enables Traxxas iD equipped battery chargers to
    immediately set and enhance charge settings for specific battery
MAXX cable high-efficiency 12 gauge silicone jacketed wire

INCLUDES:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo 3S Battery with High
    Existing Adapter and Integrated Balance Plug

REQUIRES:
LiPo suitable charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECS:
Setup: 3S1P
Constant Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

REMARKS:
ALWAYS utilize a LiPo-approved Battery charger
ALWAYS utilize a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents greater than 1C
NEVER Trickle Charge
NEVER allow to Discharge listed below 2.5V per cell
NEVER disassemble or customize pack wiring in any way or puncture cells
NEVER place on flammable products or leave ignored throughout
    charging
ALWAYS Charge in a fireproof location
ALWAYS set charger's output volts to match battery volts
ALWAYS keep out of reach of children

Below is another thing that compliments the thing being discussed.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the Air Conditioner Powered Traxxas EZ-Peak 100W Double Battery Battery charger
with iD Auto Battery Identification.

FEATURES:
Charges 2S and 3S LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD innovation immediately sets up and optimizes charge
    settings for Traxxas iD equipped batteries
Charges two batteries all at once at up to 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the same time
Advanced Mode for complete manual control of charger settings
Development bar and audible alerts
Storage Mode prepares LiPo batteries for prolonged storage
One Month restricted service warranty through Traxxas starting at date of
    purchase

INCLUDES:
Traxxas EZ-Peak 100W Double Battery Battery charger with Air Conditioner Power Cable,
    Guidelines, Cooling Fan

SPECS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (dual mode), 5-8A (high output mode)
Discharge Current Variety: 500mA
Existing Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Dimensions: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This thing is frequently acquired with the above pointed out thing.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Characteristic Include;

**Exclusive Self-Righting Action, if car rolls upside down**
**just press a button on the transmitter and in many cases**
**the X-Maxx will flip upright onto its wheels.**

**One handed body install and removal system**
**removes body posts and pins.**

**Battery Retention System removes body clips or hook and loop straps**

**Shock towers also serve as bring deals with and level supports**
    **when car is positioned upside down for maintenance.**

**Extra Technical Details Will Be Added When It Appears.**

FEATURES:
Traxxas Stability Management (TSM): Superior tuning algorithms work on
    high-speed electronic components to control wheel spin and steering
    direction on loose dirt, concrete as well as ice and snow. TSM can be
    tweaked or shut off by changing the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design supplies easy access
    to crucial components, lower front and rear skids and incorporated
    nerf bars for front, rear and side impact defense
Drive Four wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that eliminate axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design removes flexing, keyed pins lock equipment
    mesh in restaurant
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry all set
    receiver, BEC voltage and motor temperature level sensing units set up,
    self righting button, integrated fail safe,
    can be equipped with the TQi Docking Base in addition to the iPhone,
    iPad or iPod touch* to produce a graphical user interface for the
    car Traxxas Link TQi Wireless Module required (not suched as)
Guiding Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo suitable
Transmission; Single speed
Differentials: Sealed solidified steel bevel, oil filled, restricted slip
Slipper Clutch: Double fan cooled
Battery Retention System: Integrated into chassis leading brace for
    greater rigidity, removes body clips or hook and loop straps,
    adjustable for various batteries
Body: ProGraphix painted and trimmed
Body Mount System: Quick one-hand body setup and removal,
    pivoting rear lock system removes body posts and clips
Suspension: Captured high-strength steel pins, double sheer
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean reducing seal wear
Shock Towers: Composite plastic construction, also serve as bring
    deals with and level supports when car is positioned upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with impact cushions
    behind each bumper to soften blows and contribute to durability
Ball Bearings: Sealed, complete contact
Radio Box: Water resistant

INCLUDES:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Upkeep Tools

REQUIRES:
Batteries: Two 3S LiPo 5000mAh or greater
Battery Battery charger: Suitable with selected LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECS:
Automobile;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) distance from outer edges of wheels
    determined side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1pounds (8.66kg)
Ride Height: 13.79" (350mm)
Total Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

REMARKS:
Available in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings use:
    Qty. Size Place Qty. Bearing Set