Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C THREE LiPo Battery.

FEATURES:
Semi rigid construction does not require a difficult case and gets rid of
    wire harness ports that can loosen up and fail
Engineered specifically to fit Traxxas designs
New high present port with gold-plated copper terminals and
    incorporated balance port
iD Automobile Battery Recognition permits Traxxas iD geared up battery chargers to
    instantly set and optimize charge settings for specific battery
MAXX cable television high-efficiency 12 gauge silicone jacketed wire

CONSISTS OF:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo THREE Battery with High
    Current Adapter and Integrated Balance Plug

REQUIRES:
LiPo suitable battery charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECS:
Setup: 3S1P
Continuous Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

COMMENTS:
ALWAYS use a LiPo-approved Battery charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents greater than 1C
NEVER EVER Trickle Charge
NEVER permit to Discharge listed below 2.5V per cell
NEVER dismantle or customize pack electrical wiring in any way or puncture cells
NEVER put on flammable materials or leave unattended during
    charging
ALWAYS Charge in a fire-resistant area
ALWAYS set battery charger's output volts to match battery volts
ALWAYS stay out of reach of kids

Here is one more item that praises the item being talked about.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the A/C Powered Traxxas EZ-Peak 100W Double Battery Battery charger
with iD Automobile Battery Identification.

FEATURES:
Charges TWO and THREE LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD technology instantly configures and enhances charge
    settings for Traxxas iD geared up batteries
Charges two batteries at the same time at as much as 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the same time
Advanced Mode for full manual control of battery charger settings
Progress bar and audible alerts
Storage Mode prepares LiPo batteries for prolonged storage
1 Month restricted guarantee through Traxxas starting at date of
    purchase

CONSISTS OF:
Traxxas EZ-Peak 100W Double Battery Battery charger with A/C Power Cord,
    Guidelines, Cooling Fan

SPECS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (double mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Current Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Dimensions: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This item is regularly bought with the above pointed out item.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Characteristic Include;

**Special Self-Righting Action, if vehicle rolls upside down**
**simply push a button on the transmitter and most of the times**
**the X-Maxx will flip upright onto its wheels.**

**One handed body mount and removal system**
**gets rid of body posts and pins.**

**Battery Retention System gets rid of body clips or hook and loop straps**

**Shock towers also serve as bring manages and level supports**
    **when vehicle is put upside down for maintenance.**

**Extra Technical Info Will Be Included When It Becomes Available.**

FEATURES:
Traxxas Stability Management (TSM): Superior tuning algorithms operate on
    high-speed electronic parts to control wheel spin and steering
    instructions on loose dirt, concrete as well as ice and snow. TSM can be
    fine tuned or switched off by changing the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design supplies easy access
    to critical parts, lower front and rear skids and incorporated
    nerf bars for front, rear and side impact security
Drive 4 wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that remove axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design gets rid of flexing, keyed pins lock gear
    mesh in restaurant
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry ready
    receiver, BEC voltage and motor temperature sensors set up,
    self righting button, integrated fail safe,
    can be geared up with the TQi Docking Base in addition to the iPhone,
    iPad or iPod touch* to create a graphical user interface for the
    vehicle Traxxas Link TQi Wireless Module needed (not suched as)
Steering Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo suitable
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, restricted slip
Slipper Clutch: Double fan cooled
Battery Retention System: Integrated into chassis top brace for
    greater rigidness, gets rid of body clips or hook and loop straps,
    adjustable for various batteries
Body: ProGraphix painted and trimmed
Body Mount System: Quick one-hand body setup and removal,
    rotating rear latch mechanism gets rid of body posts and clips
Suspension: Recorded high-strength steel pins, double large
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean lowering seal wear
Shock Towers: Composite plastic construction, also serve as bring
    manages and level supports when vehicle is put upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with impact cushions
    behind each bumper to soften blows and add to toughness
Ball Bearings: Sealed, full contact
Radio Box: Waterproof

CONSISTS OF:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Maintenance Tools

REQUIRES:
Batteries: Two THREE LiPo 5000mAh or greater
Battery Battery charger: Suitable with picked LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECS:
Automobile;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) distance from external edges of wheels
    determined side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1lbs (8.66kg)
Ride Height: 13.79" (350mm)
Overall Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

COMMENTS:
Offered in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings usage:
    Qty. Size Area Qty. Bearing Set