Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C 3S LiPo Battery.

FEATURES:
Semi rigid building does not require a hard case and eliminates
    wire harness connectors that can loosen up and fail
Engineered specifically to fit Traxxas models
New high present connector with gold-plated copper terminals and
    integrated balance connector
iD Automobile Battery Identification allows Traxxas iD equipped chargers to
    automatically set and optimize charge settings for particular battery
MAXX cable high-efficiency 12 gauge silicone jacketed wire

INCLUDES:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo 3S Battery with High
    Existing Connector and Integrated Balance Plug

NEEDS:
LiPo suitable battery charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECS:
Setup: 3S1P
Constant Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Measurements: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

REMARKS:
ALWAYS use a LiPo-approved Battery charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER EVER Trickle Charge
NEVER allow to Release listed below 2.5V per cell
NEVER take apart or customize pack electrical wiring in any method or puncture cells
NEVER place on flammable materials or leave unattended during
    charging
ALWAYS Charge in a fireproof area
ALWAYS set battery charger's output volts to match battery volts
CONSTANTLY keep out of reach of children

Below is an additional item that praises the item being talked about.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the Air Conditioning Powered Traxxas EZ-Peak 100W Dual Battery Battery charger
with iD Automobile Battery Identification.

FEATURES:
Charges TWO and 3S LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD technology automatically configures and enhances charge
    settings for Traxxas iD equipped batteries
Charges 2 batteries concurrently at approximately 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the same time
Advanced Mode for complete manual control of battery charger settings
Development bar and audible informs
Storage Mode prepares LiPo batteries for extended storage
Thirty Days limited guarantee through Traxxas starting at date of
    purchase

INCLUDES:
Traxxas EZ-Peak 100W Dual Battery Battery charger with Air Conditioning Power Cable,
    Directions, Cooling Fan

SPECS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (double mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Existing Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Measurements: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This item is frequently acquired with the above stated item.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Characteristic Include;

**Special Self-Righting Action, if car rolls upside down**
**just push a button on the transmitter and in most cases**
**the X-Maxx will flip upright onto its wheels.**

**One handed body mount and elimination system**
**eliminates body posts and pins.**

**Battery Retention System eliminates body clips or hook and loop straps**

**Shock towers also work as carrying deals with and level supports**
    **when car is positioned upside down for upkeep.**

**Extra Technical Details Will Be Added When It Appears.**

FUNCTIONS:
Traxxas Stability Management (TSM): Superior tuning algorithms work on
    high-speed electronic components to manage wheel spin and steering
    direction on loose dirt, concrete as well as ice and snow. TSM can be
    fine tuned or turned off by changing the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design provides simple access
    to critical components, lower front and rear skids and integrated
    nerf bars for front, rear and side impact defense
Drive 4 wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that remove axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design eliminates flexing, keyed pins lock gear
    mesh in place
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry prepared
    receiver, BEC voltage and motor temperature level sensing units installed,
    self righting button, integrated fail safe,
    can be equipped with the TQi Docking Base along with the iPhone,
    iPad or iPod touch* to produce a visual user interface for the
    car Traxxas Link TQi Wireless Module needed (not included)
Guiding Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo suitable
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, limited slip
Slipper Clutch: Dual fan cooled
Battery Retention System: Integrated into chassis top brace for
    higher rigidity, eliminates body clips or hook and loop straps,
    adjustable for different batteries
Body: ProGraphix painted and trimmed
Body Mount System: Quick one-hand body installation and elimination,
    pivoting rear latch system eliminates body posts and clips
Suspension: Caught high-strength steel pins, double sheer
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean lowering seal wear
Shock Towers: Composite plastic building, also work as carrying
    deals with and level supports when car is positioned upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with impact cushions
    behind each bumper to soften blows and add to sturdiness
Ball Bearings: Sealed, complete contact
Radio Box: Water resistant

INCLUDES:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Upkeep Tools

NEEDS:
Batteries: Two 3S LiPo 5000mAh or higher
Battery Battery charger: Suitable with picked LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECS:
Vehicle;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) distance from outer edges of wheels
    determined side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1lbs (8.66kg)
Trip Height: 13.79" (350mm)
Overall Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

REMARKS:
Available in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings use:
    Qty. Size Area Qty. Bearing Set