Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C 3S LiPo Battery.

FEATURES:
Semi stiff construction does not require a tough case and gets rid of
    wire harness adapters that can loosen and fail
Engineered specifically to fit Traxxas designs
New high present connector with gold-plated copper terminals and
    incorporated balance connector
iD Car Battery Identification allows Traxxas iD equipped chargers to
    automatically set and optimize charge settings for specific battery
MAXX cable high-efficiency 12 gauge silicone jacketed wire

CONSISTS OF:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo 3S Battery with High
    Existing Adapter and Integrated Balance Plug

REQUIRES:
LiPo compatible battery charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECIFICATIONS:
Setup: 3S1P
Continuous Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

COMMENTS:
ALWAYS utilize a LiPo-approved Charger
ALWAYS utilize a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER Trickle Charge
NEVER permit to Discharge below 2.5V per cell
NEVER dismantle or customize pack wiring in any method or leak cells
NEVER place on flammable products or leave unattended during
    charging
ALWAYS Charge in a fire-resistant area
ALWAYS set battery charger's output volts to match battery volts
CONSTANTLY shut out of reach of children

Right here is an additional item that compliments the item being gone over.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the Air Conditioning Powered Traxxas EZ-Peak 100W Dual Battery Charger
with iD Car Battery Identification.

FEATURES:
Charges 2S and 3S LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD technology automatically sets up and enhances charge
    settings for Traxxas iD equipped batteries
Charges 2 batteries simultaneously at as much as 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the very same time
Advanced Mode for complete manual control of battery charger settings
Development bar and audible signals
Storage Mode prepares LiPo batteries for prolonged storage
One Month minimal guarantee through Traxxas beginning at date of
    purchase

CONSISTS OF:
Traxxas EZ-Peak 100W Dual Battery Charger with Air Conditioning Power Cord,
    Instructions, Cooling Fan

SPECIFICATIONS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (dual mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Existing Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Dimensions: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This item is regularly acquired with the above mentioned item.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Characteristic Include;

**Unique Self-Righting Action, if automobile rolls upside down**
**simply press a button on the transmitter and in most cases**
**the X-Maxx will flip upright onto its wheels.**

**One handed body mount and removal system**
**gets rid of body posts and pins.**

**Battery Retention System gets rid of body clips or hook and loop straps**

**Shock towers also work as bring deals with and level supports**
    **when automobile is put upside down for maintenance.**

**Additional Technical Info Will Be Included When It Appears.**

FUNCTIONS:
Traxxas Stability Management (TSM): Superior tuning algorithms work on
    high-speed electronic parts to manage wheel spin and steering
    instructions on loose dirt, concrete as well as ice and snow. TSM can be
    tweaked or turned off by adjusting the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design supplies simple access
    to critical parts, lower front and rear skids and incorporated
    nerf bars for front, rear and side effect defense
Drive Four wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that get rid of axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design gets rid of flexing, keyed pins lock gear
    mesh in place
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry prepared
    receiver, BEC voltage and motor temperature sensors set up,
    self righting button, integrated fail safe,
    can be equipped with the TQi Docking Base together with the iPhone,
    iPad or iPod touch* to produce a visual user interface for the
    automobile Traxxas Link TQi Wireless Module needed (not consisted of)
Steering Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo compatible
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, minimal slip
Slipper Clutch: Dual fan cooled
Battery Retention System: Integrated into chassis top brace for
    higher rigidness, gets rid of body clips or hook and loop straps,
    adjustable for various batteries
Body: ProGraphix painted and trimmed
Body Mount System: Quick one-hand body installation and removal,
    pivoting rear lock mechanism gets rid of body posts and clips
Suspension: Recorded high-strength steel pins, double large
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean reducing seal wear
Shock Towers: Composite plastic construction, also work as bring
    deals with and level supports when automobile is put upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with effect cushions
    behind each bumper to soften blows and contribute to sturdiness
Ball Bearings: Sealed, complete contact
Radio Box: Water resistant

CONSISTS OF:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Maintenance Tools

REQUIRES:
Batteries: Two 3S LiPo 5000mAh or higher
Battery Charger: Suitable with picked LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECIFICATIONS:
Car;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) range from outer edges of wheels
    determined side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1pounds (8.66kg)
Ride Height: 13.79" (350mm)
General Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

COMMENTS:
Readily available in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings usage:
    Qty. Size Place Qty. Bearing Set