Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C 3S LiPo Battery.

FEATURES:
Semi stiff building and construction does not need a tough case and gets rid of
    wire harness ports that can loosen and fail
Engineered specifically to fit Traxxas designs
New high current port with gold-plated copper terminals and
    incorporated balance port
iD Automobile Battery Recognition enables Traxxas iD equipped chargers to
    instantly set and enhance charge settings for particular battery
MAXX cable television high-efficiency 12 gauge silicone jacketed wire

SUCHES AS:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo 3S Battery with High
    Present Adapter and Integrated Balance Plug

REQUIRES:
LiPo compatible charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECS:
Configuration: 3S1P
Continuous Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Dimensions: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

COMMENTS:
ALWAYS use a LiPo-approved Battery charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents greater than 1C
NEVER Trickle Charge
NEVER allow to Release listed below 2.5V per cell
NEVER dismantle or customize pack circuitry in any method or puncture cells
NEVER put on combustible products or leave ignored during
    charging
ALWAYS Charge in a fire-resistant location
ALWAYS set charger's output volts to match battery volts
CONSTANTLY shut out of reach of kids

Right here is an additional thing that praises the thing being talked about.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the AC Powered Traxxas EZ-Peak 100W Double Battery Battery charger
with iD Automobile Battery Identification.

FEATURES:
Charges 2S and 3S LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD technology instantly configures and enhances charge
    settings for Traxxas iD equipped batteries
Charges 2 batteries simultaneously at as much as 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the very same time
Advanced Mode for complete manual control of charger settings
Development bar and audible alerts
Storage Mode prepares LiPo batteries for prolonged storage
One Month minimal warranty through Traxxas beginning at date of
    purchase

SUCHES AS:
Traxxas EZ-Peak 100W Double Battery Battery charger with AC Power Cable,
    Guidelines, Cooling Fan

SPECS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (dual mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Present Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Dimensions: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This thing is regularly purchased with the above pointed out thing.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Characteristic Include;

**Special Self-Righting Action, if vehicle rolls upside down**
**simply push a button on the transmitter and in many cases**
**the X-Maxx will turn upright onto its wheels.**

**One handed body mount and removal system**
**gets rid of body posts and pins.**

**Battery Retention System gets rid of body clips or hook and loop straps**

**Shock towers also function as carrying deals with and level supports**
    **when vehicle is placed upside down for maintenance.**

**Extra Technical Info Will Be Included When It Appears.**

FEATURES:
Traxxas Stability Management (TSM): Superior tuning algorithms run on
    high-speed electronic elements to control wheel spin and steering
    direction on loose dirt, concrete as well as ice and snow. TSM can be
    fine tuned or turned off by adjusting the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design offers easy access
    to important elements, lower front and rear skids and incorporated
    nerf bars for front, rear and side effect protection
Drive Four wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that remove axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design gets rid of flexing, keyed pins lock gear
    mesh in location
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry all set
    receiver, BEC voltage and motor temperature sensors installed,
    self righting button, integrated fail safe,
    can be equipped with the TQi Docking Base together with the iPhone,
    iPad or iPod touch* to produce a visual user interface for the
    vehicle Traxxas Link TQi Wireless Module needed (not suched as)
Guiding Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo compatible
Transmission; Single speed
Differentials: Sealed solidified steel bevel, oil filled, minimal slip
Slipper Clutch: Double fan cooled
Battery Retention System: Integrated into chassis leading brace for
    greater rigidness, gets rid of body clips or hook and loop straps,
    adjustable for various batteries
Body: ProGraphix painted and cut
Body Mount System: Quick one-hand body installation and removal,
    pivoting rear latch mechanism gets rid of body posts and clips
Suspension: Captured high-strength steel pins, double sheer
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean decreasing seal wear
Shock Towers: Composite plastic building and construction, also function as carrying
    deals with and level supports when vehicle is placed upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with effect cushions
    behind each bumper to soften blows and contribute to durability
Ball Bearings: Sealed, complete contact
Radio Box: Water resistant

SUCHES AS:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Maintenance Tools

REQUIRES:
Batteries: 2 3S LiPo 5000mAh or greater
Battery Battery charger: Suitable with picked LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECS:
Car;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) distance from external edges of wheels
    measured side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1lbs (8.66kg)
Trip Height: 13.79" (350mm)
General Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

COMMENTS:
Offered in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings usage:
    Qty. Size Place Qty. Bearing Set