Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C 3S LiPo Battery.

FEATURES:
Semi rigid building does not need a difficult case and removes
    wire harness adapters that can loosen up and fail
Engineered specifically to fit Traxxas designs
New high present port with gold-plated copper terminals and
    integrated balance port
iD Car Battery Recognition allows Traxxas iD geared up battery chargers to
    instantly set and enhance charge settings for specific battery
MAXX cable high-efficiency 12 gauge silicone jacketed wire

SUCHES AS:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo 3S Battery with High
    Existing Connector and Integrated Balance Plug

REQUIRES:
LiPo compatible charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECIFICATIONS:
Setup: 3S1P
Continuous Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Measurements: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

REMARKS:
ALWAYS use a LiPo-approved Charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents greater than 1C
NEVER EVER Trickle Charge
NEVER enable to Discharge listed below 2.5V per cell
NEVER disassemble or modify pack electrical wiring in any method or leak cells
NEVER place on flammable products or leave ignored throughout
    charging
ALWAYS Charge in a fire-resistant place
ALWAYS set charger's output volts to match battery volts
ALWAYS keep out of reach of kids

Right here is an additional product that praises the product being talked about.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the AC Powered Traxxas EZ-Peak 100W Double Battery Charger
with iD Car Battery Identification.

FEATURES:
Charges TWO and 3S LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD innovation instantly sets up and optimizes charge
    settings for Traxxas iD geared up batteries
Charges two batteries at the same time at as much as 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the very same time
Advanced Mode for full manual control of charger settings
Progress bar and audible alerts
Storage Mode prepares LiPo batteries for extended storage
Thirty Days restricted service warranty through Traxxas starting at date of
    purchase

SUCHES AS:
Traxxas EZ-Peak 100W Double Battery Charger with AC Power Cord,
    Instructions, Cooling Fan

SPECIFICATIONS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (dual mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Existing Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Measurements: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This product is often gotten with the above mentioned product.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Ingenious New Features Include;

**Unique Self-Righting Action, if vehicle rolls upside down**
**just push a button on the transmitter and in most cases**
**the X-Maxx will flip upright onto its wheels.**

**One handed body mount and elimination system**
**removes body posts and pins.**

**Battery Retention System removes body clips or hook and loop straps**

**Shock towers likewise function as carrying handles and level supports**
    **when vehicle is positioned upside down for upkeep.**

**Extra Technical Information Will Be Added When It Becomes Available.**

FUNCTIONS:
Traxxas Stability Management (TSM): Superior tuning algorithms run on
    high-speed electronic components to control wheel spin and steering
    direction on loose dirt, concrete and even ice and snow. TSM can be
    fine tuned or shut off by adjusting the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design offers simple access
    to critical components, lower front and rear skids and integrated
    nerf bars for front, rear and side impact security
Drive 4 wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that remove axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design removes flexing, keyed pins lock equipment
    mesh in place
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry all set
    receiver, BEC voltage and motor temperature level sensing units set up,
    self righting button, integrated fail safe,
    can be geared up with the TQi Docking Base in addition to the iPhone,
    iPad or iPod touch* to produce a graphical user interface for the
    vehicle Traxxas Link TQi Wireless Module needed (not suched as)
Steering Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo compatible
Transmission; Single speed
Differentials: Sealed hardened steel bevel, oil filled, restricted slip
Slipper Clutch: Double fan cooled
Battery Retention System: Integrated into chassis leading brace for
    greater rigidity, removes body clips or hook and loop straps,
    adjustable for different batteries
Body: ProGraphix painted and trimmed
Body Mount System: Quick one-hand body setup and elimination,
    rotating rear lock mechanism removes body posts and clips
Suspension: Recorded high-strength steel pins, double sheer
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean minimizing seal wear
Shock Towers: Composite plastic building, likewise function as carrying
    handles and level supports when vehicle is positioned upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with impact cushions
    behind each bumper to soften blows and contribute to durability
Ball Bearings: Sealed, full contact
Radio Box: Waterproof

SUCHES AS:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Maintenance Tools

REQUIRES:
Batteries: 2 3S LiPo 5000mAh or greater
Battery Charger: Compatible with selected LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECIFICATIONS:
Vehicle;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) range from external edges of wheels
    determined side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1lbs (8.66kg)
Ride Height: 13.79" (350mm)
General Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

REMARKS:
Available in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings use:
    Qty. Size Place Qty. Bearing Set