Traxxas 5000Mah 11.1V 3S 25C Ml Lipo

This is the Traxxas Power Cell 11.1V 5000mAh 25C THREE LiPo Battery.

FEATURES:
Semi rigid building does not need a difficult case and removes
    wire harness ports that can loosen up and fail
Engineered specifically to fit Traxxas models
New high current adapter with gold-plated copper terminals and
    incorporated balance adapter
iD Car Battery Recognition enables Traxxas iD equipped battery chargers to
    automatically set and optimize charge settings for particular battery
MAXX cable television high-efficiency 12 gauge silicone jacketed wire

CONSISTS OF:
Traxxas Power Cell 11.1V 5000mAh 25C LiPo THREE Battery with High
    Existing Adapter and Integrated Balance Plug

NEEDS:
LiPo compatible battery charger such as the Traxxas EZ-Peak Plus, TRAP2970
LiPo charging bag

SPECS:
Setup: 3S1P
Constant Discharge: 25C (125A)
Max Burst Rate: 50C (250A)
Watt Hours: 55.5
Charge Rate: 1C (5A)
Max Charge Rate: 2C (10A)
Measurements: 6.1 x 1.02 x 1.7" (155 x 26 x 44mm)
Weight: 13.3oz (376g)

COMMENTS:
ALWAYS use a LiPo-approved Charger
ALWAYS use a LiPo Cell Balancer
NEVER Charge over 4.20V per cell
NEVER Charge at currents higher than 1C
NEVER Trickle Charge
NEVER enable to Release listed below 2.5V per cell
NEVER disassemble or customize pack circuitry in any method or puncture cells
NEVER place on combustible products or leave unattended during
    charging
ALWAYS Charge in a fire-resistant area
ALWAYS set battery charger's output volts to match battery volts
CONSTANTLY stay out of reach of children

Below is one more thing that praises the thing being reviewed.

Ez-Peak Plus Plus 100 Watt Nimh/Lipo Dual Charger W/ Id System

This is the Air Conditioning Powered Traxxas EZ-Peak 100W Dual Battery Charger
with iD Car Battery Identification.

FEATURES:
Charges 2S and THREE LiPo batteries
5-8 cell NiMH batteries
Traxxas's iD technology automatically configures and optimizes charge
    settings for Traxxas iD equipped batteries
Charges two batteries simultaneously at up to 50W (4 amps) each, or
    charges single battery at 100W (8 amp) output in High-Output
    mode
Charges a NiMH and LiPo at the exact same time
Advanced Mode for complete manual control of battery charger settings
Development bar and audible informs
Storage Mode prepares LiPo batteries for extended storage
1 Month restricted guarantee through Traxxas beginning at date of
    purchase

CONSISTS OF:
Traxxas EZ-Peak 100W Dual Battery Charger with Air Conditioning Power Cable,
    Guidelines, Cooling Fan

SPECS:
Input Power: 100-240V/50-60Hz
Output: 100W max
Charge Current: 1-4A (double mode), 5-8A (high output mode)
Discharge Current Range: 500mA
Existing Drain for Balance Ports: 500mA
Weight: 20.3oz (575g)
Measurements: 7 x 5.4 x 2.2" (176 x 138 x 57mm)

This thing is frequently purchased with the above pointed out thing.



This is the 2.4GHz Radio Controlled, Brushless Electric Powered,
Ready to Run Traxxas X-Maxx.

Innovative New Characteristic Include;

**Exclusive Self-Righting Action, if automobile rolls upside down**
**simply press a button on the transmitter and in most cases**
**the X-Maxx will turn upright onto its wheels.**

**One handed body install and removal system**
**removes body posts and pins.**

**Battery Retention System removes body clips or hook and loop straps**

**Shock towers likewise work as bring deals with and level supports**
    **when automobile is placed upside down for upkeep.**

**Additional Technical Details Will Be Added When It Appears.**

FUNCTIONS:
Traxxas Stability Management (TSM): Superior tuning algorithms run on
    high-speed electronic components to control wheel spin and steering
    direction on loose dirt, concrete and even ice and snow. TSM can be
    fine tuned or turned off by adjusting the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Composite nylon tub, modular design offers simple access
    to important components, lower front and rear skids and incorporated
    nerf bars for front, rear and side effect defense
Drive 4 wheel shaft drive, high-strength steel CV driveshafts with
    splined wheel hexes that eliminate axle pins, aluminum splined
    center driveshaft
Brushless Motor: Velineon 1600, 4 pole 1600Kv, 5mm shaft, aluminum
    heat sink
Motor Mount: Cradle design removes flexing, keyed pins lock gear
    mesh in place
Radio: 2.4GHz TQi transmitter with 5-ch micro TSM telemetry ready
    receiver, BEC voltage and motor temperature level sensing units set up,
    self righting button, integrated fail safe,
    can be equipped with the TQi Docking Base along with the iPhone,
    iPad or iPod touch* to create a graphical user interface for the
    automobile Traxxas Link TQi Wireless Module required (not consisted of)
Steering Servo: High-torque with aluminum heat sink, double shear
    bearing supported servo horn
Electronic Speed Control: Velineon VXL-6s 6S LiPo compatible
Transmission; Single speed
Differentials: Sealed solidified steel bevel, oil filled, restricted slip
Slipper Clutch: Dual fan cooled
Battery Retention System: Integrated into chassis top brace for
    higher rigidity, removes body clips or hook and loop straps,
    adjustable for various batteries
Body: ProGraphix painted and trimmed
Body Mount System: Quick one-hand body installation and removal,
    pivoting rear latch mechanism removes body posts and clips
Suspension: Captured high-strength steel pins, double sheer
    connections, adjustable roll center
Shocks: GTX aluminum bodied, oil-filled, integrated wiper seal keeps
    shafts clean decreasing seal wear
Shock Towers: Composite plastic building, likewise work as bring
    deals with and level supports when automobile is placed upside down
Tires: Aggressive all-terrain tread 8 x 4 x 4"
    foam inserts
Wheels: 4.3x5.7 inches (110x145mm), 17mm hexes
Steering: Bellcrank
Bumpers: Front and rear composite plastic with effect cushions
    behind each bumper to soften blows and add to resilience
Ball Bearings: Sealed, complete contact
Radio Box: Waterproof

CONSISTS OF:
RTR X-Maxx Truck with Brushless Motor, Radio, ESC, Painted Body,
    Quick Start Guide and Upkeep Tools

NEEDS:
Batteries: Two THREE LiPo 5000mAh or higher
Battery Charger: Suitable with chosen LiPo batteries
AA Cells: For for transmitter
LiPo Charging Bag

SPECS:
Car;
Length: 29.84" (758mm)
Front Track: 22.26" (540mm)
Rear Track: 20.66" (525mm) range from outer edges of wheels
    measured side-to-side
Ground Clearance: 4" (102mm)
Weight: 19.1lbs (8.66kg)
Trip Height: 13.79" (350mm)
Overall Drive Ratio: 8.24
Wheelbase: 18.92" (480mm)
Shock Length: 7.4" (187mm)
Battery Tray Dimensions: 7.7 x 2 x 1.7" (197mm x 51.5mm x 44mm)
    Body;
Length:
Width:
Height:

COMMENTS:
Available in the following colors;
    Blue, TRAD75BB
    Red, TRAD75RR

For Replacement Ball Bearings use:
    Qty. Size Location Qty. Bearing Set