Traxxas 12T Pinion Gear 32P

This is a 12 Tooth 32 Pitch Pinion Gear for the Traxxas E-Maxx Truck.
This is the gear which is connected directly to the motor.

FEATURES:
Machined Steel
Designed for a 3mm shaft

CONSISTS OF:
One 12 tooth Pinion Gear
One 3 x 4mm Set Screw

REQUIRES:
Assembly onto an E-Maxx truck.
1.5mm hex wrench to tighten set screw.

COMMENTS:
This gear is just one of 2 which are used on the E-Maxx double motor
    set-up.

The listed below item also sets actually well with the item being gone over.

14T Pinion Gear 32P

This is a 14 Tooth 32 Pitch Pinion Gear for the Traxxas E-Maxx Truck.
This is the gear which is connected directly to the motor.

FEATURES:
Machined Steel
Designed for a 3mm shaft

CONSISTS OF:
One 14 tooth Pinion Gear
One 3 x 4mm Set Screw

REQUIRES:
Assembly onto an E-Maxx truck.
1.5mm hex wrench to tighten set screw.

COMMENTS:
This gear is just one of 2 which are used on the E-Maxx double motor
    set-up.

This is a superb enhancement to the item presently being gone over.

58T 0.8 P Spur Gear

This is the 58 Tooth Spur Gear
for the Traxxas Nitro Jato Stadium Truck.

FEATURES:
Nylon building
Black in color
.8 Module pitch

CONSISTS OF:
One 58T 0.8 Pitch Spur Gear

REQUIRES:
Assembly onto vehicle

You will certainly love this item if you have the item just above pointed out.

13T Pinion Gear 32P

This is a 13 Tooth 32 Pitch Pinion Gear for the Traxxas E-Maxx Truck.
This is the gear which is connected directly to the motor.

FEATURES:
Machined Steel
Designed for a 3mm shaft

CONSISTS OF:
One 13 tooth Pinion Gear
One 3 x 4mm Set Screw

REQUIRES:
Assembly onto an E-Maxx truck.
1.5mm hex wrench to tighten set screw.

COMMENTS:
This gear is just one of 2 which are used on the E-Maxx double motor
    set-up.

Want an additional fantastic item to match the above pointed out item?

15T Pinion Gear 32P

This is a 15 Tooth 32 Pitch Pinion Gear for the Traxxas E-Maxx Truck.
This is the gear which is connected directly to the motor.

FEATURES:
Machined Steel
Designed for a 3mm shaft

CONSISTS OF:
One 15 tooth Pinion Gear
One 3 x 4mm Set Screw

REQUIRES:
Assembly onto an E-Maxx truck.
1.5mm hex wrench to tighten set screw.

COMMENTS:
This gear is just one of 2 which are used on the E-Maxx double motor
    set-up.

This is a superb enhancement to the item presently being gone over.

10 X 15 X 4Mm Ball Bearing (2) Blue Rubber Sheild Revo

This is a set of 10x15mm Ball Bearings for usage on the Traxxas Revo.

FEATURES:
Steel Construction
Shielded with blue rubber seals

CONSISTS OF:
2 Ball Bearings

REQUIRES:
Assembly to vehicle

SPECS:
Inner Diameter: 10mm
Outer Diameter: 15mm
Side Thickness: 4mm

REMARKS:
These bearings are used to support the Main Clutch (one required).