Traxxas 1/10 Bandit VXL RTR w/Stability Management

This is the 1/10 Scale, 2.4GHz Radio Controlled, Ready-to-Run
Traxxas Outlaw VXL Brushless Motor Powered Off-Road Buggy
with Traxxas Stability Management.

Equipped with the Velineon Extreme Brushless Power System consisting of;
Exclusive Waterproof Style
Traxxas High Current Adapter
Maxx Cable 12 Gauge Wire
Velineon 3500 Brushless Motor
Velineon VXL-3s Fwd/Rev/Brake Electronic Speed Control

FUNCTIONS:
Traxxas Stability Management (TSM): Superior tuning algorithms operate on
    high-speed electronic components to control wheel spin and steering
    direction on loose dirt, concrete as well as ice and snow. TSM can be
    tweaked or turned off by adjusting the multi-function knob on
    the TQi transmitter or the slider in the Traxxas Link app
Chassis: Fiber composite bathtub style .15" (4mm) thick
Drive: Rear wheel drive
Motor: Traxxas Velineon 3500 brushless
Radio: Traxxas TQi 2.4GHz Direct Series Spread Spectrum (DSSS)
    programmable system with Traxxas Link automatic model acknowledgment
    that permits up to 20 Traxxas Link receivers and transmitters to be
    bound, transmitter immediately recalls settings for any
    previously bound receiver
Speed Control: Traxxas Velineon VXL-3s Forward/Reverse/Brake
Battery: 8.4V 7-cell NiMH 3000mAh Traxxas Power Cell
Battery Battery charger: 110V A/C powered
Shocks: Ultra Shocks with powder layered White springs
Gearbox: Sealed
Differentials: Planetary equipment type with hardened steel equipments
Transmission: Three equipment variable ratio with sealed ball bearings and
    telescoping driveshafts
Slipper Clutch: Revo Spec Torque-Control-adjustable to provide
    consistent traction control
Tires: Alias 2.2 racing tires, stepped pin back and ribbed front
Wheels: 2.2" (56mm) Black Chrome finish Tracer 5-spoke
Body: Traxxas ProGraphix painted body with wing
Bumpers: Front, Black plastic
Suspension: Live axle front with focused kingpin
Camber Tie Rods: Repaired non-adjustable
Steering Tie Rods: Adjustable with Jato style steel turnbuckles and
    strong rod ends
Steering: Bell-crank with laydown servo placement and servo saver
    new design front steering spindles with 5x11mm rubber sealed
    bearings

INCLUDES:
Traxxas Outlaw VXL, Velineon Brushless motor, Velineon VXL-3s ESC,
26 tooth pinion equipment, Black-Chrome tracer 2.2" wheels, radio,
76 spur equipment, directions, wrenches, aftermarket servo adapters,
pre-load spacers & shock pistons, battery pad, replacement screws,
body clips and washers, 7-cell battery, charger, Traxxas
Stability Management

NEEDS:
AA Batteries: 4 for transmitter
Misc. Items: Building and track devices

SPECS:
LORRY-
Length: 16.26" (413mm)
Width: 10.25 (260mm)
Height: 7.3" (186mm)
Weight: 3.0" (1380g) with body
Wheelbase: 11.58" (294mm)
Tread: Front- 9.1" (232mm) Rear- 8.25" (209mm) side-to-side at wheel
    centers
Front Track: 10.16" (258mm)
Rear Track: 9.92" (252mm)
Ground Clearance: 1" (25mm)
    BODY-
Length: 14.75" (375mm)
Width: 5.4" (138mm) at rear wheels (best point)
1.5" (39mm) behind from wheels (thinnest point)
Height: 3.7" (95mm)

COMMENTS:
The DuraTrax Element 3900kV Brushless System (DTXC3122) is an ideal,
    cost effective upgrade for this vehicle.

For replacement ball bearings use:
    Qty. Size Place Bearing Set
    4 5x11mm Front Wheels order 2 DTXC1547
    4 5x11mm Rear Wheels order 2 DTXC1547
    6 5x11mm Transmission order 3 DTXC1547

The TSM Outlaw is readily available in the following colors;
    Blue, TRAD36BB Red, TRAD36RR
    Black, TRAD36LL Silver, TRAD36SS