Top Flite MonoKote Flat Insignia Blue 6'

MonoKote is a Patented, Flexible High-Gloss Polyester Film that is Low-cost,
Easy, Clean, when Compared with "old made" Coverings, Quick To Use.

For fantastic covering concepts and to insure a professional finish, order
the MonoKote Covering Instructional DVD, TOPZ0105.

FEATURES:
Super Strong with a Tensile Strength of 25,000 psi (pounds/sq in)
Lightweight at Only 0.2 oz/sq feet
Dry Adhesive Triggers When Heat is Applied
Shrinks to a Drum-Tight Complete As It Cools
Fuelproof and Water resistant
More powerful and Lighter Than Conventional Silk and Dope Coverings
Might be Cleaned Up with Glass Cleaner, "409" or MonoKote Cleaner/Polish

INCLUDES:
One 6' x 26" Roll of Flat Insignia Blue Covering w/Instruction Sheet

NEEDS:
Sealing Iron (TOPR2100), Heat Gun (TOPR2000), Iron Sock (TOPR2175)

COMMENTS:
Paints, Trim Sheets, EconoKote and Different Lots of MonoKote Might
    Vary Slightly In Color Between Production Runs of These Products.
If Utilizing Three or More Rolls of the Very Same Color, it is Recommended to
    Utilize a 25' Roll To Guarantee the Very Same Dye Lot for the Entire
    Design Being Covered.
LustreKote Primer Need To Be Utilized With LustreKote Paint to Bring Out Its
    True Color.
MonoKote Trim Sheet (Gloss): TOPQ4106
MonoKote (Gloss): TOPQ0207
MonoKote is a High Temperature Covering, NOT For Usage Directly On Foam
EconoKote IS For Usage Directly On Foam, Utilize the Following:
EconoKote Covering: TOPQ2601-TOPQ2612
    (EconoKote might be used on top of, however not under MonoKote.)
**Temperature Level Varies: Flat MonoKote Uses a Greater Temperature Level to Apply.
    Connecting to Wood: 240 - 275°F (activating the glue)
    Partial Shrinking: 230 - 270°F
    Optimum Shrinking: 270 - 350°F
TECH
NOTE: The characteristics of the flat MonoKote vary somewhat from
standared MonoKote covering:
Flat MonoKote needs higher temperatures to apply than basic
MonoKote because of the flat finish. In addition to the higher temp
settings, this covering might require the iron to be in contact with
the covering and wood somewhat longer than the basic finish.
If this covering is applied too loosely, it might be difficult to get
a tight diminish with this product. Likewise, when applied loosely, it
might end up being difficult to remove any wrinkles that might appear.