Top Flite MonoKote Flat Insignia Blue 6'

MonoKote is a Patented, Flexible High-Gloss Polyester Film that is Low-cost,
Easy, Clean, when Compared with "old fashioned" Coverings, Quick To Use.

For fantastic covering concepts and to insure an expert finish, order
the MonoKote Covering Instructional DVD, TOPZ0105.

FEATURES:
Super Strong with a Tensile Strength of 25,000 psi (pounds/sq in)
Lightweight at Only 0.2 oz/sq feet
Dry Adhesive Triggers When Heat is Applied
Shrinks to a Drum-Tight End up As It Cools
Fuelproof and Water resistant
More powerful and Lighter Than Traditional Silk and Dope Coverings
May be Cleaned Up with Glass Cleaner, "409" or MonoKote Cleaner/Polish

INCLUDES:
One 6' x 26" Roll of Flat Insignia Blue Covering w/Instruction Sheet

NEEDS:
Sealing Iron (TOPR2100), Heat Gun (TOPR2000), Iron Sock (TOPR2175)

COMMENTS:
Paints, Trim Sheets, EconoKote and Various Lots of MonoKote May
    Vary A little In Color Between Production Runs of These Products.
If Using 3 or More Rolls of the Exact Same Color, it is Suggested to
    Use a 25' Roll To Ensure the Exact Same Dye Lot for the Entire
    Design Being Covered.
LustreKote Primer Must Be Utilized With LustreKote Paint to Highlight Its
    True Color.
MonoKote Trim Sheet (Gloss): TOPQ4106
MonoKote (Gloss): TOPQ0207
MonoKote is a Heat Covering, NOT For Usage Directly On Foam
EconoKote IS For Usage Directly On Foam, Use the Following:
EconoKote Covering: TOPQ2601-TOPQ2612
    (EconoKote may be used on top of, but not under MonoKote.)
**Temperature Level Varies: Flat MonoKote Uses a Greater Temperature Level to Use.
    Attaching to Wood: 240 - 275°F (activating the glue)
    Partial Shrinkage: 230 - 270°F
    Maximum Shrinkage: 270 - 350°F
TECH
KEEP IN MIND: The attributes of the flat MonoKote vary a little from
standared MonoKote covering:
Flat MonoKote requires greater temperatures to apply than basic
MonoKote because of the flat finish. In addition to the greater temperature
settings, this covering may need the iron to be in contact with
the covering and wood a little longer than the basic finish.
If this covering is applied too loosely, it may be hard to get
a tight shrink with this product. Likewise, when applied loosely, it
might become difficult to eliminate any wrinkles that may appear.