Top Flite MonoKote Flat Insignia Blue 6'

MonoKote is a Patented, Flexible High-Gloss Polyester Movie that is Low-cost,
Easy, Clean, and When Compared to "old fashioned" Coverings, Quick To Use.

For terrific covering ideas and to guarantee a professional surface, order
the MonoKote Covering Instructional DVD, TOPZ0105.

FEATURES:
Super Strong with a Tensile Strength of 25,000 psi (pounds/sq in)
Lightweight at Only 0.2 oz/sq feet
Dry Adhesive Triggers When Heat is Applied
Shrinks to a Drum-Tight End up As It Cools
Fuelproof and Waterproof
More powerful and Lighter Than Traditional Silk and Dope Coverings
Might be Cleaned with Glass Cleaner, "409" or MonoKote Cleaner/Polish

CONSISTS OF:
One 6' x 26" Roll of Flat Insignia Blue Covering w/Instruction Sheet

NEEDS:
Sealing Iron (TOPR2100), Heat Weapon (TOPR2000), Iron Sock (TOPR2175)

REMARKS:
Paints, Trim Sheets, EconoKote and Different Lots of MonoKote Might
    Vary Somewhat In Color Between Production Runs of These Products.
If Using Three or More Rolls of the Very Same Color, it is Suggested to
    Use a 25' Roll To Guarantee the Very Same Dye Lot for the Entire
    Design Being Covered.
LustreKote Primer Must Be Used With LustreKote Paint to Highlight Its
    True Color.
MonoKote Trim Sheet (Gloss): TOPQ4106
MonoKote (Gloss): TOPQ0207
MonoKote is a Heat Covering, NOT For Use Directly On Foam
EconoKote IS For Use Directly On Foam, Use the Following:
EconoKote Covering: TOPQ2601-TOPQ2612
    (EconoKote may be used on top of, but not under MonoKote.)
**Temperature Varies: Flat MonoKote Uses a Higher Temperature to Use.
    Connecting to Wood: 240 - 275°F (activating the glue)
    Partial Shrinkage: 230 - 270°F
    Optimum Shrinkage: 270 - 350°F
TECH
KEEP IN MIND: The qualities of the flat MonoKote vary slightly from
standared MonoKote covering:
Flat MonoKote needs greater temperature levels to apply than standard
MonoKote since of the flat surface. In addition to the greater temperature
settings, this covering may need the iron to be in contact with
the covering and wood slightly longer than the standard finish.
If this covering is applied too loosely, it may be tough to get
a tight shrink with this product. Also, when applied loosely, it
could become difficult to eliminate any wrinkles that may appear.