RPM Revo True-Track Rear A-Arm Conversion Kit-Blue

This is the RPM True-Track Rear A-Arm Conversion in Blue
for all variations of the Traxxas Revo.

FEATURES:
Eliminates stock rear toe links, locking in the rear toe angle at
    1.5° per side for an overall rear toe-in angle of 3°
Eliminates all rear bump steer for much better rear end tracking
    despite surface
Changes lower pivot ball with a 4mm diameter hinge pin for consistent
    rear toe angle
Keeps stock upper pivot ball to enable camber changes
Weighs an overall of 1-1/8oz (32g) less than stock components

CONSISTS OF:
Two each Upper and Lower Rear A-Arms
Two Axle Carriers
Two 4mm Hinge Pins
4 E-Clips
Two 3x16mm Shock Mount Screws
Two Aluminum Pivot Ball Set Screws
Two Delrin Pivot Ball Bushing Cups
Two 6x15mm Sealed Outer Bearings
Two 12x21mm Sealed Inner Bearings
Direction sheet

REQUIRES:
Getting rid of stock rear components

COMMENTS:
This True-Track system works with the following RPM
    components;
    RPMC8237 Front Black A-Arms
    RPMC8238 Front Blue A-Arms
    RPMC8222 Black Front Upper and Lower Left A-Arms
    RPMC8585 RPM Axle Carriers/Steering Blocks

Not suitable with the Traxxas #5356 Long Travel Rocker Set.

The below thing likewise pairs truly well with the thing being discussed.

Front Right A-Arms, For Summit, Revo & E-Revo, Blue

This is a set of RPM Blue Front Upper and Lower Right A-Arms
for the Traxxas Revo.

FEATURES:
Constructed of composite nylon
Angled leading and tracking edges eliminate dirt accumulation
No excessive A-arm endplay for more precise caster and toe angle
    settings
Big shock rod installing areas for enhanced rigidness

CONSISTS OF:
One Front Upper Right and one Front Lower Right A-Arm and one 16mm
    shock installing screw

REQUIRES:
Setting up on vehicle and attaching shock mount rod
Inspecting camber angles with Camber Gauge, RPMC7099

SPECS:
UPPER LOWER
Length: 4.9" (124mm) 5.9" (149mm)
Width: 2.5" (63mm) 2.8" (72mm)

COMMENTS:
For Upper and Lower Left A-Arms order RPMC8226.