RPM Green Gearbox Housing And Rear Mounts For Traxxas 2Wd Vehicles

This is the optional RPM Hybrid Gearbox Housing in Green
for the Traxxas 1/10 scale 2WD Slash, Stampede, E-Rustler and Bandit.

FEATURES:
0.12" (3mm) thick 6061 T6 aluminum motor plate offers strength to
    lock in gear mesh, and better heat dissipation than stock plastic
    motor plate
Motor plate is separate from rear bumper mounts removing damage to
    the plate in case of a rear crash
Molded nylon gearbox housing with stock bumper installing holes
Different housing and rear mounts permit transmission maintenance
    without impacting suspension settings
0° and 3° molded rear mounts offer tighter tolerances and less slop
    than machined parts for better camber and toe angle retention

INCLUDES:
Two Gearbox Real estates, Motor Plate, 2 0° and 2 3° Rear Mounts and
    Guidelines

The listed below item likewise sets truly well with the item being gone over.

Steel Top Drive Gear 22T

This is the 22 tooth, hardened steel leading drive gear that fits several Traxxas
automobiles. .
Includes: 1 gear just

You will like this item if you have the item previously stated.

30T Idler Gear Steel

This is the optional Steel Idler Gear for many Traxxas Vehicles.

FEATURES:
Steel building

INCLUDES:
One steel 30T idler gear

REQUIRES:
Installation on automobile

Several others have actually gotten this item together with the item that you are currently checking out.

Shaft Slipper Clutch

This is a Slipper Clutch Shaft for the Traxxas Rustler XL
and Stampede XL.

FEATURES:
Steel building
_
Roll pin pre-installed

INCLUDES:
One slipper clutch set

SPECIFICATIONS:
Length: 1.98" (50mm)
Diameter: .21" ( 5mm)

REMARKS:
This part will fit both the standard and XL version of the Rustler
or Stampede.

Want an additional wonderful item to compliment the above pointed out item?

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing building
Blue rubber dirt guards

INCLUDES:
(2) 5X11mm ball bearings, Part #5116

SPECIFICATIONS:
Inside size: 3/16" (5mm)
Outdoors size: 7/16" (11mm)
Width: 5/32" (4mm)